ardupilot/ArduCopter/control_land.cpp

289 lines
10 KiB
C++

/// -*- tab-width: 4; Mode: C++; c-basic-offset: 4; indent-tabs-mode: nil -*-
#include "Copter.h"
static bool land_with_gps;
static uint32_t land_start_time;
static bool land_pause;
// land_init - initialise land controller
bool Copter::land_init(bool ignore_checks)
{
// check if we have GPS and decide which LAND we're going to do
land_with_gps = position_ok();
if (land_with_gps) {
// set target to stopping point
Vector3f stopping_point;
wp_nav.get_loiter_stopping_point_xy(stopping_point);
wp_nav.init_loiter_target(stopping_point);
}
// initialize vertical speeds and leash lengths
pos_control.set_speed_z(wp_nav.get_speed_down(), wp_nav.get_speed_up());
pos_control.set_accel_z(wp_nav.get_accel_z());
// initialise position and desired velocity
pos_control.set_alt_target(inertial_nav.get_altitude());
pos_control.set_desired_velocity_z(inertial_nav.get_velocity_z());
land_start_time = millis();
land_pause = false;
// reset flag indicating if pilot has applied roll or pitch inputs during landing
ap.land_repo_active = false;
return true;
}
// land_run - runs the land controller
// should be called at 100hz or more
void Copter::land_run()
{
if (land_with_gps) {
land_gps_run();
}else{
land_nogps_run();
}
}
// land_run - runs the land controller
// horizontal position controlled with loiter controller
// should be called at 100hz or more
void Copter::land_gps_run()
{
// if not auto armed or landed or motor interlock not enabled set throttle to zero and exit immediately
if (!motors.armed() || !ap.auto_armed || ap.land_complete || !motors.get_interlock()) {
#if FRAME_CONFIG == HELI_FRAME // Helicopters always stabilize roll/pitch/yaw
// call attitude controller
attitude_control.input_euler_angle_roll_pitch_euler_rate_yaw(0, 0, 0, get_smoothing_gain());
attitude_control.set_throttle_out(0,false,g.throttle_filt);
#else
motors.set_desired_spool_state(AP_Motors::DESIRED_SPIN_WHEN_ARMED);
// multicopters do not stabilize roll/pitch/yaw when disarmed
attitude_control.set_throttle_out_unstabilized(0,true,g.throttle_filt);
#endif
wp_nav.init_loiter_target();
#if LAND_REQUIRE_MIN_THROTTLE_TO_DISARM == ENABLED
// disarm when the landing detector says we've landed and throttle is at minimum
if (ap.land_complete && (ap.throttle_zero || failsafe.radio)) {
init_disarm_motors();
}
#else
// disarm when the landing detector says we've landed
if (ap.land_complete) {
init_disarm_motors();
}
#endif
return;
}
// set motors to full range
motors.set_desired_spool_state(AP_Motors::DESIRED_THROTTLE_UNLIMITED);
// pause before beginning land descent
if(land_pause && millis()-land_start_time >= LAND_WITH_DELAY_MS) {
land_pause = false;
}
land_run_horizontal_control();
land_run_vertical_control(land_pause);
}
// land_nogps_run - runs the land controller
// pilot controls roll and pitch angles
// should be called at 100hz or more
void Copter::land_nogps_run()
{
float target_roll = 0.0f, target_pitch = 0.0f;
float target_yaw_rate = 0;
// process pilot inputs
if (!failsafe.radio) {
if ((g.throttle_behavior & THR_BEHAVE_HIGH_THROTTLE_CANCELS_LAND) != 0 && rc_throttle_control_in_filter.get() > LAND_CANCEL_TRIGGER_THR){
Log_Write_Event(DATA_LAND_CANCELLED_BY_PILOT);
// exit land if throttle is high
set_mode(ALT_HOLD, MODE_REASON_THROTTLE_LAND_ESCAPE);
}
if (g.land_repositioning) {
// apply SIMPLE mode transform to pilot inputs
update_simple_mode();
// get pilot desired lean angles
get_pilot_desired_lean_angles(channel_roll->get_control_in(), channel_pitch->get_control_in(), target_roll, target_pitch, aparm.angle_max);
}
// get pilot's desired yaw rate
target_yaw_rate = get_pilot_desired_yaw_rate(channel_yaw->get_control_in());
}
// if not auto armed or landed or motor interlock not enabled set throttle to zero and exit immediately
if (!motors.armed() || !ap.auto_armed || ap.land_complete || !motors.get_interlock()) {
#if FRAME_CONFIG == HELI_FRAME // Helicopters always stabilize roll/pitch/yaw
// call attitude controller
attitude_control.input_euler_angle_roll_pitch_euler_rate_yaw(target_roll, target_pitch, target_yaw_rate, get_smoothing_gain());
attitude_control.set_throttle_out(0,false,g.throttle_filt);
#else
motors.set_desired_spool_state(AP_Motors::DESIRED_SPIN_WHEN_ARMED);
// multicopters do not stabilize roll/pitch/yaw when disarmed
attitude_control.set_throttle_out_unstabilized(0,true,g.throttle_filt);
#endif
#if LAND_REQUIRE_MIN_THROTTLE_TO_DISARM == ENABLED
// disarm when the landing detector says we've landed and throttle is at minimum
if (ap.land_complete && (ap.throttle_zero || failsafe.radio)) {
init_disarm_motors();
}
#else
// disarm when the landing detector says we've landed
if (ap.land_complete) {
init_disarm_motors();
}
#endif
return;
}
// set motors to full range
motors.set_desired_spool_state(AP_Motors::DESIRED_THROTTLE_UNLIMITED);
// call attitude controller
attitude_control.input_euler_angle_roll_pitch_euler_rate_yaw(target_roll, target_pitch, target_yaw_rate, get_smoothing_gain());
// pause before beginning land descent
if(land_pause && millis()-land_start_time >= LAND_WITH_DELAY_MS) {
land_pause = false;
}
land_run_vertical_control(land_pause);
}
void Copter::land_run_vertical_control(bool pause_descent)
{
bool navigating = pos_control.is_active_xy();
#if PRECISION_LANDING == ENABLED
bool doing_precision_landing = !ap.land_repo_active && precland.target_acquired() && navigating;
#else
bool doing_precision_landing = false;
#endif
// compute desired velocity
const float precland_acceptable_error = 25.0f;
const float precland_min_descent_speed = -10.0f;
int32_t alt_above_ground;
if (rangefinder_alt_ok()) {
alt_above_ground = rangefinder_state.alt_cm_filt.get();
} else {
if (!navigating || !current_loc.get_alt_cm(Location_Class::ALT_FRAME_ABOVE_TERRAIN, alt_above_ground)) {
current_loc.get_alt_cm(Location_Class::ALT_FRAME_ABOVE_HOME, alt_above_ground);
}
}
float cmb_rate = 0;
if (!pause_descent) {
cmb_rate = AC_AttitudeControl::sqrt_controller(LAND_START_ALT-alt_above_ground, g.p_alt_hold.kP(), pos_control.get_accel_z());
cmb_rate = constrain_float(cmb_rate, pos_control.get_speed_down(), -abs(g.land_speed));
if (doing_precision_landing && alt_above_ground < 300.0f) {
float land_slowdown = MAX(0.0f, pos_control.get_horizontal_error()*(abs(g.land_speed)/precland_acceptable_error));
cmb_rate = MIN(precland_min_descent_speed, cmb_rate+land_slowdown);
}
}
// record desired climb rate for logging
desired_climb_rate = cmb_rate;
// update altitude target and call position controller
pos_control.set_alt_target_from_climb_rate_ff(cmb_rate, G_Dt, true);
pos_control.update_z_controller();
}
void Copter::land_run_horizontal_control()
{
int16_t roll_control = 0, pitch_control = 0;
float target_yaw_rate = 0;
// relax loiter target if we might be landed
if (ap.land_complete_maybe) {
wp_nav.loiter_soften_for_landing();
}
// process pilot inputs
if (!failsafe.radio) {
if ((g.throttle_behavior & THR_BEHAVE_HIGH_THROTTLE_CANCELS_LAND) != 0 && rc_throttle_control_in_filter.get() > LAND_CANCEL_TRIGGER_THR){
Log_Write_Event(DATA_LAND_CANCELLED_BY_PILOT);
// exit land if throttle is high
if (!set_mode(LOITER, MODE_REASON_THROTTLE_LAND_ESCAPE)) {
set_mode(ALT_HOLD, MODE_REASON_THROTTLE_LAND_ESCAPE);
}
}
if (g.land_repositioning) {
// apply SIMPLE mode transform to pilot inputs
update_simple_mode();
// process pilot's roll and pitch input
roll_control = channel_roll->get_control_in();
pitch_control = channel_pitch->get_control_in();
// record if pilot has overriden roll or pitch
if (roll_control != 0 || pitch_control != 0) {
ap.land_repo_active = true;
}
}
// get pilot's desired yaw rate
target_yaw_rate = get_pilot_desired_yaw_rate(channel_yaw->get_control_in());
}
#if PRECISION_LANDING == ENABLED
bool doing_precision_landing = !ap.land_repo_active && precland.target_acquired();
// run precision landing
if (doing_precision_landing && precland_last_update_ms != precland.last_update_ms()) {
Vector3f target_pos;
precland.get_target_position(target_pos);
pos_control.set_xy_target(target_pos.x, target_pos.y);
pos_control.freeze_ff_xy();
precland_last_update_ms = precland.last_update_ms();
}
#else
bool doing_precision_landing = false;
#endif
// process roll, pitch inputs
wp_nav.set_pilot_desired_acceleration(roll_control, pitch_control);
// run loiter controller
wp_nav.update_loiter(ekfGndSpdLimit, ekfNavVelGainScaler);
// call attitude controller
attitude_control.input_euler_angle_roll_pitch_euler_rate_yaw(wp_nav.get_roll(), wp_nav.get_pitch(), target_yaw_rate, get_smoothing_gain());
}
// land_do_not_use_GPS - forces land-mode to not use the GPS but instead rely on pilot input for roll and pitch
// called during GPS failsafe to ensure that if we were already in LAND mode that we do not use the GPS
// has no effect if we are not already in LAND mode
void Copter::land_do_not_use_GPS()
{
land_with_gps = false;
}
// set_mode_land_with_pause - sets mode to LAND and triggers 4 second delay before descent starts
// this is always called from a failsafe so we trigger notification to pilot
void Copter::set_mode_land_with_pause(mode_reason_t reason)
{
set_mode(LAND, reason);
land_pause = true;
// alert pilot to mode change
AP_Notify::events.failsafe_mode_change = 1;
}
// landing_with_GPS - returns true if vehicle is landing using GPS
bool Copter::landing_with_GPS() {
return (control_mode == LAND && land_with_gps);
}