ardupilot/libraries/AP_HAL_AVR/SPIDeviceManager_APM1.cpp

53 lines
1.6 KiB
C++

#include <AP_HAL.h>
#if (CONFIG_HAL_BOARD == HAL_BOARD_APM1 || CONFIG_HAL_BOARD == HAL_BOARD_APM2)
#include <avr/io.h>
#include <AP_HAL.h>
#include "SPIDriver.h"
#include "SPIDevices.h"
#include "GPIO.h"
#include "pins_arduino_mega.h"
using namespace AP_HAL_AVR;
extern const AP_HAL::HAL& hal;
void APM1SPIDeviceManager::init(void* machtnichts) {
/* dataflow cs is on arduino pin 53, PORTB0 */
AVRDigitalSource* df_cs = new AVRDigitalSource(_BV(0), PB);
/* dataflash: divide clock by 2 to 8Mhz, set SPI_MODE_3
* spcr gets 0x0C to set SPI_MODE_3
* spsr gets bit SPI2X for clock divider */
_dataflash = new AVRSPI0DeviceDriver(df_cs, 0x0C, _BV(SPI2X));
_dataflash->init();
/* optflow cs is on Arduino pin 34, PORTC3 */
AVRDigitalSource* opt_cs = new AVRDigitalSource(_BV(3), PC);
/* optflow: divide clock by 8 to 2Mhz
* spcr gets bit SPR0, spsr gets bit SPI2X */
_optflow = new AVRSPI0DeviceDriver(opt_cs, _BV(SPR0), 0);
_optflow->init();
/* adc cs is on Arduino pin 33, PORTC4 */
AVRDigitalSource* adc_cs = new AVRDigitalSource(_BV(4), PC);
/* adc: ubbr2 gets value of 2 to run at 2.6Mhz
* (config value cribbed from AP_ADC_ADS7844 driver pre-port) */
_adc = new AVRSPI2DeviceDriver(adc_cs, 0, 2);
_adc->init();
}
AP_HAL::SPIDeviceDriver* APM1SPIDeviceManager::device(enum AP_HAL::SPIDevice d)
{
switch (d) {
case AP_HAL::SPIDevice_Dataflash:
return _dataflash;
case AP_HAL::SPIDevice_ADS7844:
return _adc;
case AP_HAL::SPIDevice_ADNS3080_SPI0:
return _optflow;
default:
return NULL;
};
}
#endif