..
APM_Config.h
Plane: added HIL_MODE parameter
2015-03-13 22:52:56 +11:00
APM_Config.h.reference
Plane: cleanup HIL defines
2014-02-15 05:29:46 +11:00
ArduPlane.cpp
Plane: nonfunctional change, comment only. Units were in old in comment
2016-02-12 12:14:38 -08:00
Attitude.cpp
Plane: new param LAND_THEN_NEUTRL
2016-02-16 23:40:44 -08:00
GCS_Mavlink.cpp
Plane: add SYS_STATUS reverse_motor
2016-02-11 18:46:01 +11:00
Log.cpp
Plane: make throttle signed (pos and neg)
2016-02-09 14:18:02 +11:00
Makefile
Plane: cleanup cruft in Makefile
2013-10-13 21:41:01 +11:00
Makefile.waf
waf: use single entry point for make wrappers
2015-12-10 10:40:34 +09:00
Parameters.cpp
Plane: new param LAND_THEN_NEUTRL
2016-02-16 23:40:44 -08:00
Parameters.h
Plane: new param LAND_THEN_NEUTRL
2016-02-16 23:40:44 -08:00
Parameters.pde
Plane: added blank Parameters.pde for MissionPlanner
2015-05-30 15:21:33 +09:00
Plane.cpp
AP_HAL: make code not depend on concrete HAL implementations
2015-10-21 09:16:07 +11:00
Plane.h
Plane: Reverse Thrust
2016-02-09 14:18:02 +11:00
adsb.cpp
Plane: refactored interface
2015-12-31 15:36:49 +11:00
altitude.cpp
Plane: add flight stage LAND_PREFLARE
2016-02-09 14:18:02 +11:00
arming_checks.cpp
Plane: restrict rudder arming where reverse_thrust is enabled and commanding negative
2016-02-10 22:18:06 -08:00
capabilities.cpp
Plane: init vehicle capabilities
2015-08-05 16:08:49 +09:00
commands.cpp
Plane: Text revisions
2015-11-26 07:56:52 +11:00
commands_logic.cpp
Plane: Reverse Thrust
2016-02-09 14:18:02 +11:00
commands_process.cpp
Plane: convert from .pde to .cpp files
2015-05-21 07:48:52 +10:00
config.h
ArduPlane: remove check for AVR CPUs
2015-11-04 12:14:15 +11:00
control_modes.cpp
Plane: added OVERRIDE_SAFETY parameter
2016-01-29 12:20:14 +11:00
createTags
ArduPlane: don't use avr include dir for tags
2015-11-04 12:14:16 +11:00
defines.h
Plane: Reverse Thrust
2016-02-09 14:18:02 +11:00
events.cpp
Plane: add flight stage LAND_PREFLARE
2016-02-09 14:18:02 +11:00
failsafe.cpp
Plane: require 5 channels to run failsafe passthrough
2015-09-07 09:16:14 +10:00
geofence.cpp
ArduPlane: avoid comparison between signed and unsigned
2015-12-01 16:28:18 -02:00
is_flying.cpp
Plane: run is_crashed at 5hz instead of 1hz
2016-02-08 21:13:04 -08:00
landing.cpp
Plane: Reverse Thrust
2016-02-09 14:18:02 +11:00
make.inc
Plane: added QLOITER mode
2016-01-09 07:38:52 +11:00
navigation.cpp
Plane: added parameter RTL_RADIUS
2016-01-19 15:04:30 +11:00
parachute.cpp
Plane: Text revisions
2015-11-26 07:56:52 +11:00
px4_mixer.cpp
Plane: Only resend the mixer configuration if its changed
2016-01-29 12:20:14 +11:00
quadplane.cpp
Plane: compile warning fix
2016-02-17 14:54:02 -08:00
quadplane.h
Plane: support all types of multicopters in quadplane
2016-02-08 11:00:19 +11:00
radio.cpp
Plane: restrict rudder arming where reverse_thrust is enabled and commanding negative
2016-02-10 22:18:06 -08:00
release-notes.txt
Plane: prepare for 3.5.0 release
2016-01-30 13:04:51 +11:00
sensors.cpp
Plane: add flight stage LAND_PREFLARE
2016-02-09 14:18:02 +11:00
setup.cpp
Replace use of UARTDriver::printf_P() with UARTDriver::printf()
2015-10-30 14:35:25 +09:00
system.cpp
Plane: make throttle_percentage() signed
2016-02-11 18:46:01 +11:00
takeoff.cpp
Plane: zero course error for straight bungee launch
2016-01-05 11:20:14 +11:00
test.cpp
Plane: allow for settable main loop rate
2015-12-27 14:57:19 +09:00
wscript
waf: ardupilotwaf: prefix build context methods with ap_
2016-01-22 20:10:29 -02:00
d0edfa5dfa