ardupilot/ArduPlane/control_modes.pde

72 lines
2.4 KiB
Plaintext

/// -*- tab-width: 4; Mode: C++; c-basic-offset: 4; indent-tabs-mode: nil -*-
static void read_control_switch()
{
byte switchPosition = readSwitch();
// we look for changes in the switch position. If the
// RST_SWITCH_CH parameter is set, then it is a switch that can be
// used to force re-reading of the control switch. This is useful
// when returning to the previous mode after a failsafe or fence
// breach. This channel is best used on a momentary switch (such
// as a spring loaded trainer switch).
if (oldSwitchPosition != switchPosition ||
(g.reset_switch_chan != 0 &&
APM_RC.InputCh(g.reset_switch_chan-1) > RESET_SWITCH_CHAN_PWM)) {
set_mode(flight_modes[switchPosition]);
oldSwitchPosition = switchPosition;
prev_WP = current_loc;
// reset navigation integrators
// -------------------------
reset_I();
}
if (g.inverted_flight_ch != 0) {
// if the user has configured an inverted flight channel, then
// fly upside down when that channel goes above INVERTED_FLIGHT_PWM
inverted_flight = (control_mode != MANUAL && APM_RC.InputCh(g.inverted_flight_ch-1) > INVERTED_FLIGHT_PWM);
}
}
static byte readSwitch(void){
uint16_t pulsewidth = APM_RC.InputCh(g.flight_mode_channel - 1);
if (pulsewidth > 1230 && pulsewidth <= 1360) return 1;
if (pulsewidth > 1360 && pulsewidth <= 1490) return 2;
if (pulsewidth > 1490 && pulsewidth <= 1620) return 3;
if (pulsewidth > 1620 && pulsewidth <= 1749) return 4; // Software Manual
if (pulsewidth >= 1750) return 5; // Hardware Manual
return 0;
}
static void reset_control_switch()
{
oldSwitchPosition = 0;
read_control_switch();
}
static void update_servo_switches()
{
#if CONFIG_APM_HARDWARE != APM_HARDWARE_APM2
if (!g.switch_enable) {
// switches are disabled in EEPROM (see SWITCH_ENABLE option)
// this means the EEPROM control of all channel reversal is enabled
return;
}
// up is reverse
// up is elevon
g.mix_mode = (PINL & 128) ? 1 : 0; // 1 for elevon mode
if (g.mix_mode == 0) {
g.channel_roll.set_reverse((PINE & 128) ? true : false);
g.channel_pitch.set_reverse((PINE & 64) ? true : false);
g.channel_rudder.set_reverse((PINL & 64) ? true : false);
} else {
g.reverse_elevons = (PINE & 128) ? true : false;
g.reverse_ch1_elevon = (PINE & 64) ? true : false;
g.reverse_ch2_elevon = (PINL & 64) ? true : false;
}
#endif
}