mirror of https://github.com/ArduPilot/ardupilot
32 lines
1.0 KiB
C
32 lines
1.0 KiB
C
// -*- tab-width: 4; Mode: C++; c-basic-offset: 4; indent-tabs-mode: nil -*-
|
|
|
|
// THIS IS A SAMPLE CONFIGURATION FILE FOR DOING HARDWARE IN THE LOOP TESTING USING THE MAVLINK HIL INTERFACE
|
|
// IF YOU WANTED TO USE THIS YOU WOULD COPY THE CONTENTS INTO YOUR APM_Config.h FILE!
|
|
|
|
|
|
// Enable Autopilot Flight Mode
|
|
#define FLIGHT_MODE_CHANNEL 8
|
|
#define FLIGHT_MODE_1 AUTO
|
|
#define FLIGHT_MODE_2 RTL
|
|
#define FLIGHT_MODE_3 FLY_BY_WIRE_A
|
|
#define FLIGHT_MODE_4 FLY_BY_WIRE_B
|
|
#define FLIGHT_MODE_5 LEARNING
|
|
#define FLIGHT_MODE_6 MANUAL
|
|
|
|
// HIL_MODE SELECTION
|
|
//
|
|
// Mavlink supports
|
|
// 1. HIL_MODE_ATTITUDE : simulated position, airspeed, and attitude
|
|
// 2. HIL_MODE_SENSORS: full sensor simulation
|
|
#define HIL_MODE HIL_MODE_ATTITUDE
|
|
|
|
// Sensors
|
|
// All sensors are supported in all modes.
|
|
// The magnetometer is not used in
|
|
// HIL_MODE_ATTITUDE but you may leave it
|
|
// enabled if you wish.
|
|
#define AIRSPEED_SENSOR ENABLED
|
|
#define MAGNETOMETER ENABLED
|
|
#define AIRSPEED_CRUISE 25
|
|
#define THROTTLE_FAILSAFE ENABLED
|