mirror of https://github.com/ArduPilot/ardupilot
70 lines
1.6 KiB
C++
70 lines
1.6 KiB
C++
|
|
|
|
#include <avr/io.h>
|
|
|
|
#include <AP_HAL.h>
|
|
#include "SPIDevices.h"
|
|
#include "GPIO.h"
|
|
#include "Semaphore.h"
|
|
#include "pins_arduino_mega.h"
|
|
using namespace AP_HAL_AVR;
|
|
|
|
extern const AP_HAL::HAL& hal;
|
|
|
|
AVRSemaphore AVRSPI2DeviceDriver::_semaphore;
|
|
|
|
void AVRSPI2DeviceDriver::init() {
|
|
AVRDigitalSource spi2_miso(_BV(0), PH);
|
|
spi2_miso.mode(GPIO_INPUT);
|
|
|
|
AVRDigitalSource spi2_mosi(_BV(1), PH);
|
|
spi2_mosi.mode(GPIO_OUTPUT);
|
|
|
|
AVRDigitalSource spi2_sck(_BV(2), PH);
|
|
spi2_sck.mode(GPIO_OUTPUT);
|
|
|
|
/* UMSELn1 and UMSELn2: USART in SPI Master mode */
|
|
UCSR2C = _BV(UMSEL21) | _BV(UMSEL20);
|
|
/* Enable RX and TX. */
|
|
UCSR2B = _BV(RXEN2) | _BV(TXEN2);
|
|
|
|
/* Setup chip select pin */
|
|
_cs_pin->mode(GPIO_OUTPUT);
|
|
_cs_pin->write(1);
|
|
}
|
|
|
|
AP_HAL::Semaphore* AVRSPI2DeviceDriver::get_semaphore() {
|
|
return &_semaphore;
|
|
}
|
|
|
|
void AVRSPI2DeviceDriver::cs_assert() {
|
|
/* set the device UCSRnC configuration bits.
|
|
* only sets data order, clock phase, and clock polarity bits (lowest
|
|
* three bits) */
|
|
const uint8_t new_ucsr2c = UCSR2C | (_ucsr2c & (0x07));
|
|
UCSR2C = new_ucsr2c;
|
|
/* set the device baud rate */
|
|
UBRR2 = _ubrr2;
|
|
|
|
_cs_pin->write(0);
|
|
}
|
|
|
|
void AVRSPI2DeviceDriver::cs_release() {
|
|
_cs_pin->write(1);
|
|
}
|
|
|
|
uint8_t AVRSPI2DeviceDriver::transfer(uint8_t data) {
|
|
/* Wait for empty transmit buffer */
|
|
while ( !( UCSR2A & _BV(UDRE2)) ) ;
|
|
|
|
/* Put data into buffer, sends the data */
|
|
UDR2 = data;
|
|
|
|
/* Wait for data to be received */
|
|
while ( !(UCSR2A & _BV(RXC2)) ) ;
|
|
|
|
/* Get and return received data from buffer */
|
|
return UDR2;
|
|
}
|
|
|