ardupilot/ArduSub/control_brake.cpp

74 lines
2.4 KiB
C++

/// -*- tab-width: 4; Mode: C++; c-basic-offset: 4; indent-tabs-mode: nil -*-
#include "Copter.h"
/*
* control_brake.pde - init and run calls for brake flight mode
*/
// brake_init - initialise brake controller
bool Copter::brake_init(bool ignore_checks)
{
if (position_ok() || ignore_checks) {
// set desired acceleration to zero
wp_nav.clear_pilot_desired_acceleration();
// set target to current position
wp_nav.init_brake_target(BRAKE_MODE_DECEL_RATE);
// initialize vertical speed and acceleration
pos_control.set_speed_z(BRAKE_MODE_SPEED_Z, BRAKE_MODE_SPEED_Z);
pos_control.set_accel_z(BRAKE_MODE_DECEL_RATE);
// initialise position and desired velocity
pos_control.set_alt_target(inertial_nav.get_altitude());
pos_control.set_desired_velocity_z(inertial_nav.get_velocity_z());
return true;
}else{
return false;
}
}
// brake_run - runs the brake controller
// should be called at 100hz or more
void Copter::brake_run()
{
// if not auto armed set throttle to zero and exit immediately
if(!ap.auto_armed) {
wp_nav.init_brake_target(BRAKE_MODE_DECEL_RATE);
#if FRAME_CONFIG == HELI_FRAME // Helicopters always stabilize roll/pitch/yaw
// call attitude controller
attitude_control.input_euler_angle_roll_pitch_euler_rate_yaw_smooth(0, 0, 0, get_smoothing_gain());
attitude_control.set_throttle_out(0,false,g.throttle_filt);
#else // multicopters do not stabilize roll/pitch/yaw when disarmed
attitude_control.set_throttle_out_unstabilized(0,true,g.throttle_filt);
#endif
pos_control.relax_alt_hold_controllers(get_throttle_pre_takeoff(0)-throttle_average);
return;
}
// relax stop target if we might be landed
if (ap.land_complete_maybe) {
wp_nav.loiter_soften_for_landing();
}
// if landed immediately disarm
if (ap.land_complete) {
init_disarm_motors();
}
// run brake controller
wp_nav.update_brake(ekfGndSpdLimit, ekfNavVelGainScaler);
// call attitude controller
attitude_control.input_euler_angle_roll_pitch_euler_rate_yaw(wp_nav.get_roll(), wp_nav.get_pitch(), 0.0f);
// body-frame rate controller is run directly from 100hz loop
// update altitude target and call position controller
pos_control.set_alt_target_from_climb_rate_ff(0.0f, G_Dt, false);
pos_control.update_z_controller();
}