mirror of https://github.com/ArduPilot/ardupilot
53 lines
1.8 KiB
C
53 lines
1.8 KiB
C
|
|
// -*- tab-width: 4; Mode: C++; c-basic-offset: 4; indent-tabs-mode: nil -*-
|
|
|
|
// This file is just a placeholder for your configuration file. If you wish to change any of the setup parameters from
|
|
// their default values, place the appropriate #define statements here.
|
|
|
|
// For example if you wanted the Port 3 baud rate to be 38400 you would add a statement like the one below (uncommented)
|
|
//#define SERIAL3_BAUD 38400
|
|
//#define GCS_PROTOCOL GCS_PROTOCOL_NONE
|
|
|
|
#define CONFIG_APM_HARDWARE APM_HARDWARE_APM1
|
|
|
|
#define LITE DISABLED // if LITE is ENABLED, you may use an APM1280 or APM2560 CPU only (IMU less) with a GPS MT3329
|
|
// if LITE is DISABLED, this is for a full APM v1 (Oilpan + GPS MT3329 + Magnetometer HMC5883L) or APM v2
|
|
|
|
#define CLI_ENABLED ENABLED
|
|
#define CLI_SLIDER_ENABLED DISABLED
|
|
#define CLOSED_LOOP_NAV ENABLED
|
|
#define AUTO_WP_RADIUS DISABLED
|
|
|
|
#define TRACE DISABLED
|
|
|
|
//#include "APM_Config_HILmode.h" // for test in HIL mode with AeroSIM Rc 3.83
|
|
#include "APM_Config_Rover.h" // to be used with the real Traxxas model Monster Jam Grinder
|
|
|
|
// Radio setup:
|
|
// APM INPUT (Rec = receiver)
|
|
// Rec ch1: Roll
|
|
// Rec ch2: Throttle
|
|
// Rec ch3: Pitch
|
|
// Rec ch4: Yaw
|
|
// Rec ch5: not used
|
|
// Rec ch6:
|
|
// Rec ch7: Option channel to 2 positions switch
|
|
// Rec ch8: Mode channel to 3 positions switch
|
|
// APM OUTPUT
|
|
// Ch1: Wheel servo (direction)
|
|
// Ch2: not used
|
|
// Ch3: to the motor ESC
|
|
// Ch4: not used
|
|
|
|
// The following are the recommended settings for Xplane simulation. Remove the leading "/* and trailing "*/" to enable:
|
|
|
|
/*
|
|
#define HIL_PROTOCOL HIL_PROTOCOL_MAVLINK
|
|
#define HIL_MODE HIL_MODE_ATTITUDE
|
|
#define HIL_PORT 0
|
|
#define GCS_PROTOCOL GCS_PROTOCOL_MAVLINK
|
|
#define GCS_PORT 3
|
|
*/
|
|
|
|
|