/// -*- tab-width: 4; Mode: C++; c-basic-offset: 4; indent-tabs-mode: nil -*- // Code to detect a crash main ArduCopter code #ifndef CRASH_CHECK_ITERATIONS_MAX # define CRASH_CHECK_ITERATIONS_MAX 20 // 2 second (ie. 10 iterations at 10hz) inverted indicates a crash #endif #ifndef CRASH_CHECK_ANGLE_DEVIATION_CD # define CRASH_CHECK_ANGLE_DEVIATION_CD 2000 // 20 degrees beyond angle max is signal we are inverted #endif #ifndef CRASH_CHECK_ALT_CHANGE_LIMIT_CM # define CRASH_CHECK_ALT_CHANGE_LIMIT_CM 50 // baro altitude must not change by more than 50cm #endif // crash_check - disarms motors if a crash has been detected // crashes are detected by the vehicle being more than 20 degrees beyond it's angle limits continuously for more than 1 second // should be called at 10hz void crash_check() { static uint8_t inverted_count; // number of iterations we have been inverted static int32_t baro_alt_prev; // return immediately if motors are not armed or pilot's throttle is above zero if (!motors.armed() || (g.rc_3.control_in != 0 && !failsafe.radio)) { inverted_count = 0; return; } // return immediately if we are not in an angle stabilize flight mode or we are flipping if (control_mode == ACRO || ap.do_flip) { inverted_count = 0; return; } // check angles int32_t lean_max = g.angle_max + CRASH_CHECK_ANGLE_DEVIATION_CD; if (labs(ahrs.roll_sensor) > lean_max || labs(ahrs.pitch_sensor) > lean_max) { inverted_count++; // if we have just become inverted record the baro altitude if (inverted_count == 1) { baro_alt_prev = baro_alt; // exit if baro altitude change indicates we are moving (probably falling) }else if (labs(baro_alt - baro_alt_prev) > CRASH_CHECK_ALT_CHANGE_LIMIT_CM) { inverted_count = 0; return; // check if inverted for 2 seconds }else if (inverted_count >= CRASH_CHECK_ITERATIONS_MAX) { // log an error in the dataflash Log_Write_Error(ERROR_SUBSYSTEM_CRASH_CHECK, ERROR_CODE_CRASH_CHECK_CRASH); // send message to gcs gcs_send_text_P(SEVERITY_HIGH,PSTR("Crash: Disarming")); // disarm motors init_disarm_motors(); } }else{ // we are not inverted so reset counter inverted_count = 0; } }