# SITL-on-HW notes

## Compiling and flashing

Run the sitl-on-hw.sh script to compile and flash for MatekH743.  Adjust for your own board if required before running.  This script will configure a build ready for running SITL-on-hardware and attempt to upload it to a connected board.  It includes a set of embedded parameters to configure the simulated sensors appropriately.

::

	cd $HOME/ardupilot
	./libraries/SITL/examples/on-hardware/sitl-on-hw.sh

Plane can also be simulated:

::

	cd $HOME/ardupilot
	./libraries/SITL/examples/on-hardware/sitl-on-hw.sh -v plane

## Configuring

Wipe the parameters on the board; this can be done with a mavlink command, or by setting the FORMAT_VERSION parameter to 0.

For example:

::

	STABILIZE> wipe_parameters IREALLYMEAANIT
	STABILIZE> Got COMMAND_ACK: PREFLIGHT_STORAGE: ACCEPTED
	AP: All parameters reset, reboot board
	reboot

You may need to power-cycle the board at this point.

::

	Device /dev/serial/by-id/usb-ArduPilot_MatekH743_3A0019001051393036353035-if00 reopened OK
	link 1 OK
	heartbeat OK
	disabling flow control on serial 2
	AP: Calibrating barometer
	AP: Barometer 1 calibration complete
	AP: Barometer 2 calibration complete
	Init Gyro**
	AP: ArduPilot Ready
	Suggested EK3_BCOEF_* = 16.288, EK3_MCOEF = 0.208
	Home: -35.36326 149.1652 alt=584.0000m hdg=353.0000
	Smoothing reset at 0.001
	AP: RCOut: PWM:1-13
	AP: GPS 1: detected as SITL at 115200 baud
	Time has wrapped
	Time has wrapped 5577 368458
	AP: EKF3 IMU0 initialised
	AP: EKF3 IMU1 initialised
	AP: EKF3 IMU0 tilt alignment complete
	AP: EKF3 IMU1 tilt alignment complete
	AP: EKF3 IMU1 MAG0 initial yaw alignment complete
	AP: EKF3 IMU0 MAG0 initial yaw alignment complete
	AP: PERF: 0/3999 [2653:2349] F=400Hz sd=39 Ex=0
	AP: EKF3 IMU1 forced reset
	AP: EKF3 IMU1 initialised
	AP: EKF3 IMU0 forced reset
	AP: EKF3 IMU0 initialised
	AP: EKF3 IMU1 tilt alignment complete
	AP: EKF3 IMU0 tilt alignment complete
	AP: EKF3 IMU1 MAG0 initial yaw alignment complete
	AP: EKF3 IMU0 MAG0 initial yaw alignment complete
	AP: PreArm: 3D Accel calibration needed
	AP: PERF: 0/4000 [2631:2369] F=400Hz sd=5 Ex=0
	AP: EKF3 IMU0 origin set
	AP: EKF3 IMU1 origin set
	AP: PERF: 0/4000 [2639:2362] F=400Hz sd=7 Ex=0

Force