Apply filtering to baro innovation check and and don't apply innovation checks once aiding has commenced because GPS and baro disturbances on the ground and during launch could generate a false positive
Prevents frame over-runs due to simultaneous fusion of measurements on each instance.
The offset is only applied if less than 5msec available between frames
this allows uavcan to be enabled/disabled at boot. When it is disabled
we save about 25k of memory, allowing for more options for things like
multiple EKF
num_errors should be used to detect bad bus transfers, not if we
actually read something. Since we are using i2c_sem->take_nonblocking()
failing here is more likely if the bus is shared.
We pass "sizeof(i2c_integral_frame)" to hal.i2c->readRegisters(). Since
we have a padding in i2c_integral_frame we actually read 3 bytes more
than we should. Add PACKED to the struct so this is fixed.
i2c_frame doesn't have a padding (or hole) so there isn't this problem,
but since it's also used to calculate the frame size, use PACKED there
too.
Remove the checks for HAL_CPU_CLASS > HAL_CPU_CLASS_16 and
HAL_CPU_CLASS >= HAL_CPU_CLASS_75. Corresponding dead code will be
removed on separate commits.
Remove the checks for HAL_CPU_CLASS > HAL_CPU_CLASS_16 and
HAL_CPU_CLASS >= HAL_CPU_CLASS_75. Corresponding dead code will be
removed on separate commits.
Remove the checks for HAL_CPU_CLASS > HAL_CPU_CLASS_16 and
HAL_CPU_CLASS >= HAL_CPU_CLASS_75. Corresponding dead code will be
removed on separate commits.
Remove the checks for HAL_CPU_CLASS > HAL_CPU_CLASS_16 and
HAL_CPU_CLASS >= HAL_CPU_CLASS_75. Corresponding dead code will be
removed on separate commits.
Remove the checks for HAL_CPU_CLASS > HAL_CPU_CLASS_16 and
HAL_CPU_CLASS >= HAL_CPU_CLASS_75. Corresponding dead code will be
removed on separate commits.
Remove the checks for HAL_CPU_CLASS > HAL_CPU_CLASS_16 and
HAL_CPU_CLASS >= HAL_CPU_CLASS_75. Corresponding dead code will be
removed on separate commits.
Remove the checks for HAL_CPU_CLASS > HAL_CPU_CLASS_16 and
HAL_CPU_CLASS >= HAL_CPU_CLASS_75. Corresponding dead code will be
removed on separate commits.
Remove the checks for HAL_CPU_CLASS > HAL_CPU_CLASS_16 and
HAL_CPU_CLASS >= HAL_CPU_CLASS_75. Corresponding dead code will be
removed on separate commits.
Remove the checks for HAL_CPU_CLASS > HAL_CPU_CLASS_16 and
HAL_CPU_CLASS >= HAL_CPU_CLASS_75. Corresponding dead code will be
removed on separate commits.
Data-ready pin wasn't being used before due to a bug in the Kernel with
concurrent accesses to GPIO in Intel Baytrail platforms. That has been fixed in
Kernel version 4.2.
With commit 24f4153 ("AP_HAL_Linux: RCOutput_PCA9685: group writes") a
log was introduced when we can't get the bus semaphore. However since we
are calling the non blocking method, failing there is not that unlikely
if the bus is shared. Return back to the previous behavior of not
logging.
This removes errors in the in-flight reset of the earth field states by:
1) Using a state vector and magnetometer measurement from the same time coordinate
2) Not using the AHRS trim offsets in the calculation
dtIMUactual has been spit into a separate dtDelAng and dtDelVel and dtDelVel1 and dtDelVel2 delta time in recognition of the amount of timing jitter and different update rates for the IMU's
Vibration in the 400Hz delta angles could cause the angular rate condition check for in-flight magnetic field alignment to fail.
The symptons were failure to start magnetic field learning as expected when EK2_MAG_CAL=3 was set.
The calculation of a delta rotation between consecutive magnetometer samples has been introduced instead of the most recent IMU delta angle as this is less affected by noise and give an upper bound on the angular error.
the check has been moved into the magnetometer fusion control function so that any reset will be performed using fresh magnetometer data
Explicitly set Plane parameters rather than rely on use of the default
If no type defined, default to Copter parameters (most common platform type
Enable different platform types to use different initial accel bias uncertainty
Reduce initial accel bias uncertainty for copter to prevent initial oscillation in bias and height estimate
Large baro data errors when flying without GPS could cause total failure of the EKF.
This patch provides protection against this happening in-flight but allows for large innovations during preflight alignment.
Vibration in the 400Hz delta angles could cause the angular rate condition check for in-flight magnetic field alignment to fail.
The symptons were failure to start magnetic field learning as expected when EK2_MAG_CAL=3 was set.
Use the more robust, but less accurate compass heading fusion up to 5m altitude
Wait for the magnetometer data fusion time offset to be correct before using data to reset states
Don't reset magnetic field states if the vehicle is rotating rapidly as timing offsets will produce large errors
When doing the yaw angle reset, apply the reset increment to all quaternions stored in the output buffer to avoid transients produced by yaw rotations and the 0.25 second fusion time horizon offset.
Only do the one yaw and mag reset at 5m, not two at 1.5 and 5.0m
Always re-do the yaw and mag reset when leaving the ground.
Not being able to leave the instantiation in ther header is not because
of PSTR issues, but basically because the instantiation needs to be in a
compilation unit, not in the header itself.
The only thing from AP_Progmem that's still used are the pgm_read_*
function and there's no support for AVR anymore. So remove the dead code
and use a single header to contain that inline functions.
"%S" is used for wide string, but we are passing a char*. Use lowercase
in this case to remove warnings like this:
libraries/AP_InertialSensor/AP_InertialSensor.cpp: In member function
'bool AP_InertialSensor::calibrate_accel(AP_InertialSensor_UserInteract*, float&, float&)':
libraries/AP_InertialSensor/AP_InertialSensor.cpp:620:61: warning:
format '%S' expects argument of type 'wchar_t*', but argument 3 has type 'const char*' [-Wformat=]
"Place vehicle %S and press any key.\n", msg);
^
"%S" is used for wide string, but we are passing a char*. Use lowercase
in this case to remove warnings like this:
libraries/AP_InertialSensor/AP_InertialSensor.cpp: In member function
'bool AP_InertialSensor::calibrate_accel(AP_InertialSensor_UserInteract*, float&, float&)':
libraries/AP_InertialSensor/AP_InertialSensor.cpp:620:61: warning:
format '%S' expects argument of type 'wchar_t*', but argument 3 has type 'const char*' [-Wformat=]
"Place vehicle %S and press any key.\n", msg);
^
"%S" is used for wide string, but we are passing a char*. Use lowercase
in this case to remove warnings like this:
libraries/AP_InertialSensor/AP_InertialSensor.cpp: In member function
'bool AP_InertialSensor::calibrate_accel(AP_InertialSensor_UserInteract*, float&, float&)':
libraries/AP_InertialSensor/AP_InertialSensor.cpp:620:61: warning:
format '%S' expects argument of type 'wchar_t*', but argument 3 has type 'const char*' [-Wformat=]
"Place vehicle %S and press any key.\n", msg);
^
"%S" is used for wide string, but we are passing a char*. Use lowercase
in this case to remove warnings like this:
libraries/AP_InertialSensor/AP_InertialSensor.cpp: In member function
'bool AP_InertialSensor::calibrate_accel(AP_InertialSensor_UserInteract*, float&, float&)':
libraries/AP_InertialSensor/AP_InertialSensor.cpp:620:61: warning:
format '%S' expects argument of type 'wchar_t*', but argument 3 has type 'const char*' [-Wformat=]
"Place vehicle %S and press any key.\n", msg);
^
Most of AP_Progmem is already gone so we can stop including it in most
of the places. The only places that need it are the ones using
pgm_read_*() APIs.
In some cases the header needed to be added in the .cpp since it was
removed from the .h to reduce scope. In those cases the headers were
also reordered.
prog_char and prog_char_t are now the same as char on supported
platforms. So, just change all places that use them and prefer char
instead.
AVR-specific places were not changed.
Now variables don't have to be declared with PROGMEM anymore, so remove
them. This was automated with:
git grep -l -z PROGMEM | xargs -0 sed -i 's/ PROGMEM / /g'
git grep -l -z PROGMEM | xargs -0 sed -i 's/PROGMEM//g'
The 2 commands were done so we don't leave behind spurious spaces.
AVR-specific places were not changed.
The PSTR is already define as a NOP for all supported platforms. It's
only needed for AVR so here we remove all the uses throughout the
codebase.
This was automated with a simple python script so it also converts
places which spans to multiple lines, removing the matching parentheses.
AVR-specific places were not changed.
