during the first part of a takeoff when we have not yet reached the
target airspeed this forces the throttle to maximum. This fixes a case
where the throttle may drop too low during the first part of takeoff
and lead to a stall.
recent fixes in Plane have made the stage more accurate so exceptions/hacks are no longer needed to differentiate between knowing if executing NAV_LAND vs being in stage_approach.
we now can exit an underspeed condition if we stay above min speed for
3 seconds and also reach 15% above min speed. This prevents a problem
with the thrust line causing downpitch leading to a crash due to too
much throttle
- throttle slew rate was using % full range including the negative range (-100 to +100 instead of 0 to 100) which meant it was faster
- throttle integrator windup limit was higher than normal because it's a porportional to throttle max - min but that makes no sense when min is negative causing larger limits
// @Description: This is the damping gain for the pitch demand loop. Increase to add damping to correct for oscillations in speed and height. If set to 0 then TECS_PTCH_DAMP will be used instead.
+ // @Description: This is the damping gain for the throttle demand loop during and auto-landing. Same as TECS_THR_DAMP but only in effect during an auto-land. Increase to add damping to correct for oscillations in speed and height. When set to 0 landing throttle damp is controlled by TECS_THR_DAMP.
// @Description: When zero, the flare sink rate (TECS_LAND_SINK) is a fixed sink demand. With this enabled the flare sinkrate will increase/decrease the flare sink demand as you get further beyond the LAND waypoint. Has no effect before the waypoint. This value is added to TECS_LAND_SINK proportional to distance traveled after wp. With an increasing sink rate you can still land in a given distance if you're traveling too fast and cruise passed the land point. A positive value will force the plane to land sooner proportional to distance passed land point. A negative number will tell the plane to slowly climb allowing for a pitched-up stall landing. Recommend 0.2 as initial value.
Reverse thrust for controlled landings, even with much steeper approach slopes. This is achieved by allowing throttle demand to go negative to maintain a target airspeed. A Pre-Flare stage was added, triggered by an altitude, to allow for a slower airspeed just before land. That lower airspeed can be near stall.
new params TECS_APPR_SMAX - sink rate max during approach
The problem with using min() and max() is that they conflict with some
C++ headers. Name the macros in uppercase instead. We may go case by
case later converting them to be typesafe.
Changes generated with:
git ls-files '*.cpp' '*.h' -z | xargs -0 sed -i 's/\([^_[:alnum:]]\)max(/\1MAX(/g'
git ls-files '*.cpp' '*.h' -z | xargs -0 sed -i 's/\([^_[:alnum:]]\)min(/\1MIN(/g'
Now variables don't have to be declared with PROGMEM anymore, so remove
them. This was automated with:
git grep -l -z PROGMEM | xargs -0 sed -i 's/ PROGMEM / /g'
git grep -l -z PROGMEM | xargs -0 sed -i 's/PROGMEM//g'
The 2 commands were done so we don't leave behind spurious spaces.
AVR-specific places were not changed.
Tom Pittenger
Andrew Tridgell
Michael du Breuil
Lucas De Marchi
Don Gagne
Jonathan Challinger
Caio Marcelo de Oliveira Filho