- inhibit crash detection warnings when disabled by param so now it can be completely disabled
- reset is_crashed when disabled by param
- fixed pre-takeoff detection bug by adding in_preLaunch_flight_stage() where we are actually in FLIGHT_NORMAL instead of FLIGHT_TAKEOFF during setup of bungee launches. This now detects if we're in that state
- simplified the use of been_auto_flying to check across all flight stages. before it was excluded to handle hand-launches which can now be detected with in_preLaunch_flight_stage()
- added impact detector timer to clamp is_flying a few seconds after an impact
- logging new impact detector as "STAT.Hit"
There is no crosstrack concept in the loiter navigation so when going from waypoint to loiter you will not converge onto the line between those two points. This commit adds crosstracking by performing normal waypoint navigation until you get near it.
prog_char and prog_char_t are now the same as char on supported
platforms. So, just change all places that use them and prefer char
instead.
AVR-specific places were not changed.
Now variables don't have to be declared with PROGMEM anymore, so remove
them. This was automated with:
git grep -l -z PROGMEM | xargs -0 sed -i 's/ PROGMEM / /g'
git grep -l -z PROGMEM | xargs -0 sed -i 's/PROGMEM//g'
The 2 commands were done so we don't leave behind spurious spaces.
AVR-specific places were not changed.
The PSTR is already define as a NOP for all supported platforms. It's
only needed for AVR so here we remove all the uses throughout the
codebase.
This was automated with a simple python script so it also converts
places which spans to multiple lines, removing the matching parentheses.
AVR-specific places were not changed.
add crash detection, allow disengage via param CRASH_DETECT
improved is_flying behavior
take off, landing and hard-landing improvements
add stillness check to is_flying and log it
minimum airspeed is determined ARSPD_FBW_MIN*0.75
this fixes a bug where a mode switch change during an AUTO mission
which does not change the flight mode would cause cross tracking to be
reset, so the plane will not correctly follow the desired track
Many thanks to Michael Du Breuil for the log that showed this bug
setup the MODESWITCH channel as our OVERRIDE_CHAN, allowing for
instant manual passthru in px4io when OVERRIDE_CHAN goes above 1750
This makes for faster switching, and avoids bugs where a still enabled
FMU channel disables override
When arming we need to ensure that we don't enable any channels
otherwise PX4IO will think that FMU is active and will stop running
the internal RC mixer
Andrew Tridgell
Tom Pittenger
Michael du Breuil
Luis Vale Gonçalves
Caio Marcelo de Oliveira Filho
lvale
Lucas De Marchi
Randy Mackay
Peter Barker
squilter
ziltoid2
Andre Kjellstrup
Grant Morphett