this zeros-watchdog was caused by a SPI DMA error on STM32F405:
https://discuss.ardupilot.org/t/crash-with-4-2-0-beta-and-4-3-0-daily-bdshot/83297
we had incorrectly left these internal errors enabled when asserts
were not enabled. That led to a osalSysHalt()
without these we get an spi_fail internal error, caught by the
SPIDevice code
This addition allows for cheap testing of a STM32H755 (dual core). This borrows the setup file STM32H757xx.py, as there are almost no changes between the chips. CRSF in and out, gps, ICM20948, BMP388, settings saving to on board flash all working.
PWM(3) pin change
Changed PWM(3) pin to one exposed on connector
adding fmuv3 into the list of firmwares we might run on Solo was a late
addition to the recent PRs. It was forgotten that the inheritance would
cause a redefition failure
this fixes the flash re-init problem when flash storage fills on
H7. It was caused by rejecting writes where one or more of the 32 byte
chunks was not all 0xff but was equal to the current data. That
happens when writing to the sector header in AP_FlashStorage
it also moves the interrupt disable inside the loop to allow for
other interrupts to run between blocks
we have now shown that interrupts being enabled during flash
operations can cause the infamous "68ms" bug, or watchdog when using a
32 bit timer on boards using flash for storage
The issue is quite repeatable with a load of a very large waypoint
file (over 500 waypoints) using "wp ftpload" in MAVProxy. This puts a
huge load on flash storage.
Our current working theory is that while doing flash writes for
storage on dual-bank we block access to only one bank, so if another
thread uses a timeout function with a short timeout while the flash
write is happening and chVTDoTickI calls code which crosses the flash
bank boundary then it can cause chVTDoTickI to violate the assumption
that no more than CH_CFG_ST_DELTA ticks pass while it is calculating
the value to set in the system timer. In that case we get a delay of a
full timer wrap, which is 68ms on boards with 16 bit timer and 70
minutes on boards with 32 bit timer
Modification of CarbonixL496 to add more features.
Features:
To use internal clock of MCU, Oscillator value is set to 0.
LED pin changed from PA13 to PA15
Enabled JTAG
Add interface to GPS and ADSB.