Robert Lefebvre
bba7fdc7c3
TradHeli: ch6 tuning of ext gyro to use control_in
...
This could also be used to control the other Heli Ch7 functions (direct drive tail rotor control). This should be tidied up.
Credit: Jolyon Saunders
2013-11-15 22:58:08 +09:00
Robert Lefebvre
4426060ccc
TradHeli: COLYAW not applied when the motor is not running
2013-11-15 22:58:06 +09:00
Robert Lefebvre
9ae66c1773
TradHeli: add support for drive tail rotors
...
Repurposed external gyro and made it multi-funcitonal.
required PWM on Ch8 to start the motor in RSC Mode moved up from 100 to 400. This is to facilitate two-stage switching of the motors with PWM>100 starting the tail motor, and PWM>400 starting the main motor.
Additional amendments by Randy
2013-11-15 22:58:04 +09:00
Robert Lefebvre
232a116973
TradHeli: Use Leaky Integrator on Yaw Rate controller
...
Use when rotor is not running to prevent the rudder from slowly moving over
2013-11-15 22:58:02 +09:00
Randy Mackay
3ce16113b5
TradHeli: use landing collective when landed or landing
2013-11-15 22:58:00 +09:00
Randy Mackay
7ae0d3320b
TradHeli: add landing collective min
2013-11-15 22:57:58 +09:00
Randy Mackay
633e91b7d4
Copter: initialise roll, pitch, yaw modes to stabilize
...
This fixes a bug in which the stabilize throttle controller would be
non-tilt compensated until the user switched to another flight mode and
back again
2013-11-15 22:57:56 +09:00
Randy Mackay
ae87759e6d
TradHeli: add THROTTLE_MANUAL_HELI
...
Move check_dynamic_flight to run as scheduled task
2013-11-15 22:57:53 +09:00
Randy Mackay
1f65bb537f
TradHeli: add get_pilot_desired_collective
...
Perhaps this should be moved to the main code's heli.pde sketch
2013-11-15 22:57:51 +09:00
Randy Mackay
eaef5315bf
TradHeli: bugfix to update swash in run_rate_controllers
2013-11-15 22:57:47 +09:00
Randy Mackay
34fb70cfc7
TradHeli: formatting and param description changes
2013-11-15 22:57:45 +09:00
Randy Mackay
46118b59d7
TradHeli: integrate motor lib changes
2013-11-15 22:57:43 +09:00
Randy Mackay
13a412ee21
TradHeli: make parameters and variables private
...
add accessors for variables and params required in main code
replace tabs with spaces
2013-11-15 22:57:41 +09:00
Randy Mackay
72597cc5bd
TradHeli: remove setup via CLI
...
Saves 6k of flash
2013-11-15 22:57:39 +09:00
Randy Mackay
2cc48ffcd6
Copter: formatting and param description changes
2013-11-15 22:57:37 +09:00
Robert Lefebvre
0e2ddb0378
Copter: verify_takeoff() should set ap.takeoff_complete to True after the takeoff is complete.
2013-11-15 22:57:34 +09:00
Robert Lefebvre
c5b119288d
TradHeli: Add Motor Runup check to the auto_arming check.
2013-11-15 22:57:31 +09:00
Robert Lefebvre
f67d95ac75
TradHeli: Modify Throttle_Auto to prevent helis from pushing hard downward while running up the motor. We will set the collective pitch to stab_col_min which should result in a mild downward pressure if the user has set their parameters correctly.
2013-11-15 22:57:28 +09:00
Robert Lefebvre
ffb605d06d
TradHeli: Modify the constrain on the auto throttle controller to prevent it from commanding full down collective if we think we are on the ground still.
2013-11-15 22:57:22 +09:00
Randy Mackay
8f2c9591ff
TradHeli: dynamic_flight flag based on inertial nav speed
...
Created new heli.pde for heli_integrated_swash and check_dynamic_flight
2013-11-15 22:57:20 +09:00
Robert Lefebvre
e23e4bc7d8
TradHeli: Bug Fix on Dynamic Flight / TakeOff Detector
2013-11-15 22:57:18 +09:00
Robert Lefebvre
324c866ae1
TradHeli: Move Take-off Complete flag from the throttle controller, and into the Dynamic Flight check. This is to prevent false positive where the collective is pushed up before the motor is started.
2013-11-15 22:57:16 +09:00
Robert Lefebvre
f7c63be357
TradHeli: leaky-I-term based on dynamic_flight_detector
2013-11-15 22:57:14 +09:00
Randy Mackay
f5488bc447
HAL: MPU6k and Baro SPI to 8Mhz
2013-11-15 21:58:32 +09:00
Andrew Tridgell
08a6503364
HAL_AVR: force all devices on SPI0 to low speed when one is low speed
...
this forces MS5611 to low speed when MPU6K is low speed
2013-11-15 21:58:30 +09:00
Randy Mackay
f0f6e85b39
Copter: ARMING_CHECK made into bitmask
...
Allows arming checks to be individually enabled or disabled for baro,
compass, GPS, INS, parameters, RC and board voltage
2013-11-15 17:13:56 +09:00
Randy Mackay
fe822ba0b6
Copter: pre-arm check of INS health
2013-11-15 17:13:53 +09:00
Andrew Tridgell
71bb462ad0
AP_InertialSensor: use fabsf()
2013-11-15 10:43:10 +11:00
Andrew Tridgell
aef9289476
AP_InertialSensor: added INS_PRODUCT_ID values
2013-11-15 10:43:10 +11:00
Randy Mackay
d54b1ea446
CopterMotors: fix example sketch
2013-11-14 22:27:10 +09:00
Randy Mackay
ce045c77a4
Copter: remove unused variable from Single copter
2013-11-14 22:26:53 +09:00
proficnc
b1bd708a98
Update README.md
...
Updated build instruction link to the one on the Dev.Ardupilot wiki
2013-11-14 14:51:11 +09:00
Jason Short
371dc8c616
Copter: Drift Mode
...
Changes Toy mode declarations to Drift mode.
Requires GPS, Mode 2 transmitter
Drift mode mixes Roll, Pitch and Yaw into a single stick on mode two transmitters.
2013-11-14 14:43:15 +09:00
Randy Mackay
57b291b1c5
Copter: reject change_command if not in AUTO
2013-11-14 13:49:37 +09:00
Randy Mackay
0778454434
Copter: disarm routine shortcut
...
Extra check so we only run the disarm check when we are actually armed.
The ground stations sometimes send many disarm messages which can be
ignored
2013-11-14 13:14:51 +09:00
Randy Mackay
9d4e0a216f
Copter: parameter files for beg, int, adv and camera ship
2013-11-13 22:57:08 +09:00
Randy Mackay
bcbf0feff0
GPS Glitch: revert accel max to 10m/s/s
...
This may not be the best real world value but it keeps the autotester
from failing because it recovers from the glitch before the 5second
time-out on the GPS failsafe
2013-11-13 21:33:34 +09:00
Randy Mackay
f5b1114aea
Copter: range check pilot requested lean angles
...
This fixes a bug uncovered by MHA in which the receiver output 900 pwm
for roll and pitch to the APM which was interpreted as requesting an 80
deg lean angle which the copter then attempted to do!
2013-11-13 14:21:21 +09:00
Randy Mackay
14dc1a1c88
Copter: add @User and @Increment to motor params description
2013-11-13 12:28:59 +09:00
Randy Mackay
e53c57b0a6
Copter: default SPIN_WHEN_ARMED to zero
2013-11-13 12:28:01 +09:00
Randy Mackay
3bd124eb72
GPS Glitch: radius and accel max to 5m and 5m/s/s
2013-11-13 11:49:21 +09:00
Andrew Tridgell
6448ff455f
build: added new copter frame type 'single'
2013-11-13 09:21:21 +11:00
Andrew Tridgell
504bdd8139
build: fixed build_all for heli
2013-11-13 09:12:02 +11:00
Andrew Tridgell
6deeca1cc0
build: support all copter frame types on all boards
2013-11-13 09:12:02 +11:00
Randy Mackay
159d6320bf
Copter: move SINGLE parameters to start at 75
2013-11-12 23:40:38 +09:00
Randy Mackay
06ce98a2f4
Copter: add SINGLE_FRAME definition
2013-11-12 23:40:32 +09:00
Randy Mackay
81d83f1c55
SingleCopter: formatting changes
...
replace tab with 4-spaces
remove blank lines
2013-11-12 23:40:29 +09:00
ssq870424
07d3f2a3c5
Copter: add support for singlecopter airframe
...
this is the newest singlecopter airframe programme.
This kind of aerial vehicles include Honeywell T-hawk and Goldeneye.
2013-11-12 23:40:27 +09:00
Randy Mackay
80131ce7cc
Iris: remove ATTTITUDE_FAST, PID and OPTFLOW logging
2013-11-12 11:40:03 +09:00
Randy Mackay
13fd33c2d8
Copter: gps failsafe disabled until we get first 3d lock
2013-11-12 11:13:05 +09:00