No vertical whitespace allowed in the structures...
We concatenate all of the LogStructure files; without this we remain in
state_inside and try to parse every line in the concatenation as if it
were a log structure definition
In the case you only have a forward-pointing LIDAR we'd send messages
for each of the other orientations from proximty's horizontal-distances
array, chewing up bandwidth and processing time.
In the case you only have a forward-pointing LIDAR we'd send messages
for each of the other orientations from proximty's horizontal-distances
array, chewing up bandwidth and processing time.
This should resolve a problem in autotest where we don't detect the
fence as being breached as ArduPilot never announces the fact it has
breached - it just changes mode to RTL but the interval on the
FENCE_STATUS message never aligns with the time the vehicle is breached.
The focal-desktop appears to have a problem where directories are
considered to be in-use when being deleted. Not reproduced by me, but
reliably by a Windows user.
The stack trace is already extremely useful... but mapping back to the
relevant dataflash log is a bit of a pain.
Adding more stuff to this method in the future might be good, too.
this takes better advantage of the new UART code. Log download over
USB gets to 730 kbyte/s. For comparison, with the 4.0 code on the same
H7 we get about 300 kbyte/s
this gains about 20k of RAM, and has almost no impact on log download
speed at 921600 on a F427. The improved threading means we can afford
to have smaller buffers
refactor rcout into separate thread and process all dshot requests there
move uart DMA completion to event model
process dshot locks in strick reverse order when unlocking
convert Shared_DMA to use mutexes
move UART transmit to a thread-per-uart
do blocking UART DMA transactions
do blocking dshot DMA transactions
trim stack sizes
cancel dma transactions on dshot when timeout occurs
support contention stats on blocking locking
move thread supression into chibios_hwdef.py
invalidate DMA bounce buffer correctly
separate UART initialisation into two halves
cleanup UART transaction timeouts
add @SYS/uarts.txt
move half-duplex handling to TX thread
correct thread statistics after use of ExpandingString
set unbuffered TX thread priority owner + 1
correctly unlock serial_led_send()
don't share IMU RX on KakuteF7Mini
observe dshot pulse time more accurately.
set TRBUFF bit for UART DMA transfers
deal with UART DMA timeouts correctly
don't deadlock on reverse ordered DMA locks
change PORT_INT_REQUIRED_STACK to 128
Peter Barker
Andy Piper
Patrick José Pereira
Mirko Denecke
Andrew Tridgell
Dr.-Ing. Amilcar do Carmo Lucas
Paul Riseborough
Randy Mackay
Iampete1