rmackay9
7a0189fb2c
ArduCopter: modified mainloop timing to be in sync with the arrival of new data from the IMU.
...
This reduces the maximum delay between when new sensor data arrives and when it is actually used by about 5ms.
2012-09-10 11:37:53 +09:00
rmackay9
4e85e545bf
ArduCopter: added NUM_IMU_SAMPLES_FOR_XYZHZ definitions for MPU6000 and Oilpan to allow more syncing of the mainloop with the arrival of data from the IMU.
2012-09-10 11:37:48 +09:00
rmackay9
8f993cde2b
ArduCopter: bug fix for ROI not working if user did not have a camera mount
...
Changed verify_nav_roi command to attempt to point at the target if our camera mount type is not pan_tilt nor pan_tilt_roll
2012-09-10 02:03:32 +09:00
Andrew Tridgell
1fecd135ef
ACM: use compass.accumulate() in ArduCopter
...
this gives us a much less noisy magnetometer
2012-09-08 10:06:04 +10:00
Michael Oborne
1d0d45a95f
Fix Approach Altitude min
2012-09-06 17:43:58 +08:00
Pat Hickey
b52738662a
APM_Config.h for ArduCopter/ArduPlane: better descr of APM2_BETA_HARDWARE
2012-09-05 15:36:57 -07:00
rmackay9
af2502c739
ArduCopter: upgraded firmware version to 2.7.3
2012-09-02 12:58:16 +09:00
rmackay9
3e6966c33d
ArduCopter: fixes to allow AP_Mount to work on APM1 with original default channels and fix to reenable support for 3-axis gimbals on APM2.
...
Channels 5 to 11 changed to RC_Channel_aux.
Removed channel 9 because APM_RC doesn't support it in any case.
Updated EEPROM format version to 119 because of the change to RC_Channel_aux and because k_param_rc_11 moved to be after k_param_rc_10.
2012-09-02 12:51:23 +09:00
rmackay9
6c1bd815c1
ArduCopter: remove unnecessary references to CH_CAM_PITCH, CH_CAM_ROLL, CH_CAM_YAW
2012-09-02 12:47:27 +09:00
Craig Elder
c83d1402fb
Arducopter: Release 2.7.2
2012-08-31 19:18:10 -07:00
Andrew Tridgell
0b2cbbb677
ACM: added TELEM_DELAY to ArduCopter
2012-08-30 09:03:01 +10:00
Jason Short
0ab8b85a78
ACM Log.pde : whitespace clean up
2012-08-28 21:22:07 -07:00
Jason Short
91bc3705c1
ACM : revert back to the 2.6 climb rate calc
...
The current filter is outputting wild oscillations.
2012-08-28 21:22:07 -07:00
Craig Elder
3403e1b78d
Arducopter: increased MAVLINK delay to 6s to reduce the chance of xBee bricking
...
Arduplane: increased MAVLINK delay to 6s to reduce the chance of xBee bricking
Ardurover: increased MAVLINK delay to 6s to reduce the chance of xBee bricking
2012-08-28 20:09:10 -07:00
rmackay9
4978e0c23f
ArduCopter: increased Stabilize Roll and Pitch I term to 0.05 (was 0.01) based on feedback from Jason
2012-08-29 11:34:53 +09:00
Craig Elder
94957b3529
Arducopter: Preparing for 2.7.2 Release
2012-08-28 18:30:41 -07:00
Jason Short
b757c7130d
ACM : Logging updates
2012-08-28 15:40:08 -07:00
Jason Short
52def45ba0
ACM: Altitude Adjust
2012-08-28 15:40:08 -07:00
Jason Short
24486c75b5
ACM : Log Timing
2012-08-28 15:40:08 -07:00
rmackay9
6f236f0c3b
ArduCopter: increase SPI bus speed to 2Mhz after IMU initialisation has completed (MPU6000 accepts maximum of 1Mhz for some registers but up to 20Mhz for main sensor and interrupt registers)
2012-08-28 17:29:48 +09:00
rmackay9
ccc659e8a9
ArduCopter: reduced Rate Roll and Pitch PID values
...
RATE_ROLL_P, RATE_PITCH_P reduced to 0.165 (was 0.185)
RATE_ROLL_D, RATE_PITCH_D reduced to 0.004 (was 0.008)
2012-08-26 10:45:45 +09:00
uncrustify
593f4bad21
uncrustify ArduCopter/APM_Config.h
2012-08-21 19:19:50 -07:00
uncrustify
ad1f20924d
uncrustify ArduCopter/config.h
2012-08-21 19:19:50 -07:00
uncrustify
06031868d8
uncrustify ArduCopter/system.pde
2012-08-21 19:19:50 -07:00
uncrustify
4ae0b9dc8a
uncrustify ArduCopter/test.pde
2012-08-21 19:19:50 -07:00
uncrustify
8bb14446e5
uncrustify ArduCopter/setup.pde
2012-08-21 19:19:50 -07:00
uncrustify
700e03920a
uncrustify ArduCopter/motors.pde
2012-08-21 19:19:50 -07:00
uncrustify
a3f6cdc0bd
uncrustify ArduCopter/navigation.pde
2012-08-21 19:19:50 -07:00
uncrustify
1d56079ba2
uncrustify ArduCopter/commands_logic.pde
2012-08-21 19:19:50 -07:00
uncrustify
f8b7fdf7bb
uncrustify ArduCopter/Attitude.pde
2012-08-21 19:19:50 -07:00
uncrustify
865deed57e
uncrustify ArduCopter/Parameters.pde
2012-08-21 19:19:50 -07:00
uncrustify
e4932136d9
uncrustify ArduCopter/ArduCopter.pde
2012-08-21 19:19:50 -07:00
uncrustify
dfc77d37ca
uncrustify ArduCopter/Log.pde
2012-08-21 19:19:50 -07:00
uncrustify
5dceeed7ce
uncrustify ArduCopter/Parameters.h
2012-08-21 18:57:21 -07:00
uncrustify
6d9b4ec785
uncrustify ArduCopter/defines.h
2012-08-21 18:57:21 -07:00
uncrustify
d662339d11
uncrustify ArduCopter/config_channels.h
2012-08-21 18:57:21 -07:00
uncrustify
11cf4a78eb
uncrustify ArduCopter/UserVariables.h
2012-08-21 18:56:57 -07:00
uncrustify
f3559747b0
uncrustify ArduCopter/GCS.h
2012-08-21 18:56:56 -07:00
uncrustify
66f63fe415
uncrustify ArduCopter/APM_Config_mavlink_hil.h
2012-08-21 18:56:56 -07:00
uncrustify
196fff3d55
uncrustify ArduCopter/planner.pde
2012-08-21 18:56:56 -07:00
uncrustify
ad743cba6c
uncrustify ArduCopter/sensors.pde
2012-08-21 18:56:50 -07:00
uncrustify
c7d32df65f
uncrustify ArduCopter/UserCode.pde
2012-08-21 18:56:01 -07:00
uncrustify
e8760bec78
uncrustify ArduCopter/GCS_Mavlink.pde
2012-08-21 18:56:01 -07:00
uncrustify
fef945e2cb
uncrustify ArduCopter/flip.pde
2012-08-21 18:56:01 -07:00
uncrustify
6088067ff3
uncrustify ArduCopter/GCS.pde
2012-08-21 18:56:00 -07:00
uncrustify
1fba78b594
uncrustify ArduCopter/toy.pde
2012-08-21 18:56:00 -07:00
uncrustify
95bbbd9ff9
uncrustify ArduCopter/commands_process.pde
2012-08-21 18:56:00 -07:00
uncrustify
5ba8d42ad4
uncrustify ArduCopter/leds.pde
2012-08-21 18:55:44 -07:00
uncrustify
ccf6e80c14
uncrustify ArduCopter/commands.pde
2012-08-21 18:55:43 -07:00
uncrustify
c9953574ca
uncrustify ArduCopter/radio.pde
2012-08-21 18:55:43 -07:00
