Trim is now called again on pitch and roll, now that trimming can be done with adc_offsets. Fixed setup::motors for x frame.
git-svn-id: https://arducopter.googlecode.com/svn/trunk@1505 f9c3cf11-9bcb-44bc-f272-b75c42450872
no roll and pitch input means no change. Flicking will still update the throttle cruise value. Please check I have the signs correct!!!
git-svn-id: https://arducopter.googlecode.com/svn/trunk@1499 f9c3cf11-9bcb-44bc-f272-b75c42450872
This makes it possible to move one resistor on the APM board and feed it PPM directly from a receiver emitting a PPM stream.
git-svn-id: https://arducopter.googlecode.com/svn/trunk@1498 f9c3cf11-9bcb-44bc-f272-b75c42450872
- disable NMEA autodetection; false positives are still a risk
- trim down the console output to a minimum; we still need something to help users diagnose potential problems, but the old output was much too verbose
- rather than block forever, only do one autodetect pass for each ::read call. That's still too long (five seconds or so) but better than blocking forever.
- don't block forever if no GPS is attached.
git-svn-id: https://arducopter.googlecode.com/svn/trunk@1480 f9c3cf11-9bcb-44bc-f272-b75c42450872
This can make re-opening a port faster (as the free/malloc pair can be avoided) and possibly more robust (in the case where e.g. the heap has been corrupted).
git-svn-id: https://arducopter.googlecode.com/svn/trunk@1479 f9c3cf11-9bcb-44bc-f272-b75c42450872
Tweaked the nav pitch and roll commands to no longer use bearing error.
Angle boost is now a lot less thrust. I was getting too much added thrust when pitched at 45°
git-svn-id: https://arducopter.googlecode.com/svn/trunk@1475 f9c3cf11-9bcb-44bc-f272-b75c42450872
Added an init string for SiRF receivers that will bring them back out of the binary mode configuration that AP_GPS_Auto sets them to.
Picked up the GPS logging format from the AP_GPS_Auto test.
git-svn-id: https://arducopter.googlecode.com/svn/trunk@1469 f9c3cf11-9bcb-44bc-f272-b75c42450872
Major new features:
- No RAM buffer for the NMEA message being parsed; saves 120 bytes of RAM.
- More robust parser, a little less likely to be confused by bad messages.
- Added configuration strings for SiRF, ublox and MediaTek GPS in NMEA mode to select just the messages of interest.
Note that the issue that TinyGPS has with co-ordinates with "different" numbers of decimal digits is addressed in this code.
Size is comparable to the old parser.
git-svn-id: https://arducopter.googlecode.com/svn/trunk@1468 f9c3cf11-9bcb-44bc-f272-b75c42450872
Otherwise, we can end up settling on NMEA as a mode just after switching a SiRF GPS to binary mode.
git-svn-id: https://arducopter.googlecode.com/svn/trunk@1467 f9c3cf11-9bcb-44bc-f272-b75c42450872
This is a partial workaround for not being able to use PSTR at global scope, e.g. in an argument to a constructor; it makes the intent of the otherwise somewhat bulky declaration of the string more obvious.
git-svn-id: https://arducopter.googlecode.com/svn/trunk@1464 f9c3cf11-9bcb-44bc-f272-b75c42450872
Add support for re-opening a port without changing the baudrate or buffer sizes. By passing zero for the parameters that aren't to be changed, code can reconfigure a port without needing to know how it was originally configured.
git-svn-id: https://arducopter.googlecode.com/svn/trunk@1462 f9c3cf11-9bcb-44bc-f272-b75c42450872
Increase the no-data timeout to slightly more than a second, so that GPS' with a 1Hz update rate don't cause problems.
git-svn-id: https://arducopter.googlecode.com/svn/trunk@1461 f9c3cf11-9bcb-44bc-f272-b75c42450872
james.goppert
jasonshort
mich146@hotmail.com
deweibel@gmail.com
DrZiplok@gmail.com
DrZiplok
rmackay9@yahoo.com
gigiorm