rmackay9
6da07ef1d2
ArduCopter: increase CONTROL_SWITCH_COUNTER so that flight mode switch must be changed for at least 1/10th of a second
2012-12-06 10:31:46 +09:00
rmackay9
072ffec493
ArduCopter: allow INERTIAL_NAV to be enabled separately for horizontal and vertical position
2012-12-06 10:31:41 +09:00
rmackay9
aa5e7e63a0
ArduCopter: switch on INS in APM_Config.h (i.e. on by default for users uploading through Arduino IDE)
2012-12-06 10:31:36 +09:00
rmackay9
bdb47c449a
ArduCopter: pass linear altitude error to throttle rate controllers.
...
Previously the requested rate used the square root of the altitude error.
Scale pilot's desired vertical rate and acceleration based on ACCELERATION_MAX_Z and VELOCITY_MAX_Z #defines
2012-12-06 10:31:31 +09:00
rmackay9
d7f76ebd87
ArduCopter: add tuning of throttle rate controller's I term (THROTTLE_KI)
2012-12-06 10:31:25 +09:00
rmackay9
7b4ed2d227
ArduCopter: restored landing detector to landing throttle mode.
...
Added LAND_SPEED parameter to control the rate of descent for the last 10m of a landing.
Added CH6 tuning for accel based throttle controller.
2012-12-06 10:31:20 +09:00
rmackay9
560bb1d738
ArduCopter: removed unused AUTO_THROTTLE_HOLD #define
2012-12-06 10:31:15 +09:00
rmackay9
7035529953
ArduCopter: remove unused get_desired_climb_rate function
2012-12-06 10:31:09 +09:00
rmackay9
a94826f182
ArduCopter: add set_throttle_mode to better control initialisation of variables
2012-12-06 10:31:04 +09:00
rmackay9
1036b35128
ArduCopter: added back in angle boost and recombined for heli and multicopter
2012-12-06 10:30:55 +09:00
rmackay9
3cbef57c64
ArduCopter: first merge of leonard's accel based altitude controller plus other changes from Randy
...
Changes include:
New low-level get_throttle_accel function takes target acceleration and compares vs earth-frame Z accelerometer values to produce output to motors.
Higher level throttle controllers modified to call new get_throttle_accel controller
Throttle_rate_stabilized controller added which maintains a desired climb/descent rate
Throttle_land controller added - descends using normal auto throttle controller to 10m then descends at 50cm/s
Multiple throttle modes added including landing mode
Land flight mode no longer needs GPS
Throttle cruise maintenance moved to update_throttle_cruise function
2012-12-06 10:30:49 +09:00
Robert Lefebvre
8c18a60766
ACM: Small fix to Yaw Look Ahead
2012-12-04 14:50:14 -05:00
Robert Lefebvre
1d589c0b7d
ACM: TradHeli
...
Fixes for Attitude rate controllers.
2012-12-04 14:42:04 -05:00
Robert Lefebvre
5723021be1
ACM: TradHeli
...
Creating Rate Feed-Forward Parameters
2012-12-04 13:47:38 -05:00
Robert Lefebvre
3e65dd3ded
ACM: TradHeli APM_Config.h changes
2012-12-04 13:32:40 -05:00
Robert Lefebvre
315a7e8000
ACM: Yaw Look Ahead Changes
2012-12-04 13:26:41 -05:00
Robert Lefebvre
9130045298
ACM: Code Cleanup
2012-11-30 17:05:12 -05:00
rmackay9
8141f0b600
ArduCopter: bug fix - increase mpu6k sample rate to 100hz
2012-11-30 23:49:18 +09:00
Andrew Tridgell
6fbf5ec8f2
Copter: update ArduCopter for new ins interface
2012-11-30 07:15:18 +11:00
Michael Oborne
68aa5e4682
AC add ability to start new accel_scale via mavlink
2012-11-28 21:38:58 +08:00
Andrew Tridgell
2949d58b71
Copter: re-enable sending of GLOBAL_POSITION_INT message
...
this gives important raw GPS velocity information, plus relative and
absolute height
2012-11-28 11:26:19 +11:00
Robert Lefebvre
07d7d90882
ACM: TradHeli
...
Bringing in Low Pass Filter for Rate Controllers
2012-11-26 21:51:23 -05:00
Robert Lefebvre
6b8c39dd10
ACM: Creating Yaw_Look_Ahead yaw mode.
...
This function is not fully tested yet.
2012-11-26 21:37:13 -05:00
Robert Lefebvre
3f0e8dd358
ACM: TradHeli
...
Bringing in Low Pas Filter
Commented out because it does not build.
Needs updates to Low Pass Filter Lib
2012-11-26 21:21:12 -05:00
Robert Lefebvre
e8d619acad
ACM: Begin creation of TradHeli rate control.
...
May affect Multi-Rotors.
2012-11-26 21:02:41 -05:00
Robert Lefebvre
6b1fee767a
ACM: TradHeli
...
Creating Stab_Collective Function to allow for different collective ranges between Stabilize and other modes.
This makes for a smoother collective action in Stabilize mode with manual throttle, while still allowing full collective travel in Acro and other modes.
2012-11-26 19:37:20 -05:00
Robert Lefebvre
9e45e906fb
ACM: TradHeli
...
Move some TradHeli #defines into one place in APM_Config to clean up config.h and defines.h
2012-11-26 19:09:55 -05:00
Robert Lefebvre
b32d7c8b63
ACM: TradHeli
...
Prevent helis from arming while RSC control is switched on.
2012-11-26 19:03:28 -05:00
Robert Lefebvre
95eeda7cf7
ACM: TradHeli
...
Removing Angle Boost function.
Does not make sense for helis due to aerodynamics. Can cause more problems than it solves.
2012-11-26 18:58:21 -05:00
Robert Lefebvre
8056b78c55
ACM: TradHeli
...
Remove Rate I-term reset when throttle stick is on the bottom. This could be very bad for helis since it's plausible to use full downstick while flying.
There is obviously a risk here of building up a false I-term on the ground but this isn't a good solution for that anyway.
Also removed what appears to be some deadwood.
2012-11-26 18:49:24 -05:00
Robert Lefebvre
637c9a1a72
ACM: TradHeli
...
Removing this "throttle" output restriction for TradHelis.
2012-11-26 18:44:03 -05:00
Andrew Tridgell
5818aaad42
Copter: fixed build error
...
thanks to Marco for pointing this out
2012-11-24 20:39:35 +11:00
Andrew Tridgell
f6ec932d63
Copter: added reboot in CLI and over MAVLink
...
useful for getting out of CLI
2012-11-24 18:20:37 +11:00
Andrew Tridgell
cd07d965a7
Copter: ported RSSI_PIN option from ArduPlane
...
this is useful for OSD users
2012-11-22 20:59:33 +11:00
rmackay9
3372355e07
ArduCopter: remove commented out remnants of roll_scale_d and pitch_scale_d
2012-11-22 12:50:39 +09:00
rmackay9
eb6d8fca57
ArduCopter: added ReleaseNotes.txt
2012-11-22 09:51:04 +09:00
Robert Lefebvre
6ffc115236
Changes to get_throttle_rate()
...
Commented out a bit of code that is not used currently
Change the output constrains to #defines so they can be easily changed, particularly for use in TradHeli.
2012-11-21 17:11:38 -05:00
Andrew Tridgell
dbdb3e1194
ACM: allow fetch of parameters by index
...
this makes it more efficient to re-fetch parameters that are missing
2012-11-22 00:16:57 +11:00
Andrew Tridgell
bcae83c4f6
ACM: make it possible to run CLI on radio port in ArduCopter
2012-11-21 21:41:34 +11:00
Andrew Tridgell
704da2a5d9
MAVLink: make it possible to enter the CLI over the radio
...
this only works on the APM2, where UART0 is also the radio port
2012-11-21 14:11:05 +11:00
Michael Oborne
a5e3ce4655
remove cli planner mode - no longer used
2012-11-21 07:45:45 +08:00
Michael Oborne
0c84b8abf1
fix unit max. and unit type
2012-11-21 07:42:53 +08:00
Andrew Tridgell
bcf740a82f
ACM: support 16 character parameter names
2012-11-20 21:38:58 +11:00
Andrew Tridgell
c008ca7560
ACM: fixed documentation of disabling voltage/current pins for ArduCopter
2012-11-20 20:26:14 +11:00
Andrew Tridgell
69fbcc8683
MAVLink: fixed accel and gyro sensor offsets in MAVLink
2012-11-20 18:32:26 +11:00
rmackay9
810da878e7
ArduCopter: performance monitoring - changed loop counters to uint16_t.
...
Removed an unused items from dataflash logging of Performance.
2012-11-19 11:55:47 +09:00
Andrew Tridgell
dafaa2efc8
SITL: disable optical flow on the desktop build
...
it doesn't work yet, as no sensor emulator is available
2012-11-19 09:04:03 +11:00
Andrew Tridgell
a3c3c59b82
ACM: fixed some memory cast warnings
2012-11-19 08:42:36 +11:00
rmackay9
07a7a1acd8
ArduCopter: replaced digitalRead and digitalWrite with faster calls
...
improved performance logging to dataflash
2012-11-19 01:16:07 +09:00
Andrew Tridgell
531e62d3b5
MAVLink: improve usefulness of logged GPS velocities
...
we need them to align with time to use them for accelerations
2012-11-17 17:45:30 +11:00
