Andrew Tridgell
a9cb31a5a6
Plane: prepare for 4.2.0beta6
2022-04-28 18:18:33 +10:00
Andrew Tridgell
494df9dbca
Plane: release notes for plane 4.2.0beta6
2022-04-28 18:18:07 +10:00
Sanket Sharma
f9a5272c6e
Plane: Updated highest airspeed limit when armed
2022-04-28 12:56:34 +10:00
Andrew Tridgell
4e4b7db2b7
Plane: add Q_OPTION for RTL always on RC failsafe for ship landing
2022-04-28 12:56:34 +10:00
Andrew Tridgell
46304533a8
Plane: param conversion for INS_NOTCH to INS_HNTC2
2022-04-28 12:56:34 +10:00
Peter Barker
e3fce6635f
Plane: do not use guided waypoint for loiter location
...
Currently this waypoint is set 10,000m away by the avoidance behaviour
Instead, immediately enter loiter mode
2022-04-28 12:56:34 +10:00
Andrew Tridgell
9674489564
Plane: prepare for 4.2.0beta5
2022-04-07 10:06:25 +10:00
Andrew Tridgell
280ed2097b
Plane: release notes for 4.2.0beta5
2022-04-07 10:05:28 +10:00
Andrew Tridgell
557c96b7f6
Plane: fixed rudder control when ARMING_RUDDER != 2
...
when rudder disarm is disabled we should allow full yaw control
regardless of throttle level. We should also only disable left yaw
when throttle is at zero, as right yaw does not indicate pilot may be
trying to disarm
2022-04-07 10:05:28 +10:00
Andrew Tridgell
64d95c27c2
Plane: prepare for 4.2.0beta4 release
2022-03-28 20:53:56 +11:00
Andrew Tridgell
2b4683c30d
Plane: added release notes for 4.2.0beta4
2022-03-28 20:53:56 +11:00
Andrew Tridgell
6a769b728e
Plane: fixed yaw on the ground when rudder disarming in AUTO
...
when a quadplane touches down in an auto throttle mode the pilot may
use rudder to disarm. The check for rudder disarm was only active in
modes without auto-throttle. This expands it to all modes if the
throttle has hit the lower limit
2022-03-28 20:53:56 +11:00
Andrew Tridgell
f1f6c34132
Plane: added a value for RTL_AUTOLAND to disable arming check
...
set RTL_AUTOLAND=3 to get go-around but not RTL DO_LAND_START usage
2022-03-28 20:53:56 +11:00
Andrew Tridgell
727e066fa9
Plane: prevent rapid RTL/AUTO switching on fence breach
...
don't switch back to RTL if already in a DO_LAND_START sequence
2022-03-28 20:53:56 +11:00
Andrew Tridgell
04f464772b
Plane: when shutting down motors force outputs to minimum
...
this fixes issue #20354 where a long spool time can lead to motors
running without control for an extended period of time.
2022-03-28 20:53:56 +11:00
Andrew Tridgell
7bdeeb24e2
Plane: prepare for 4.2.0beta3
2022-03-18 20:30:00 +11:00
Andrew Tridgell
fdccae7b5e
Plane: update release notes for 4.2.0beta3
2022-03-18 20:29:33 +11:00
Tim Tuxworth
6e915df31b
Plane: Display Fence Breach message in GCS
...
Send a "Geofence breach" message to the Ground Control Station. Without this when the fence is breached and if anything happens as a result, such as RTL, it will happen silently.
2022-03-18 14:30:03 +11:00
Andrew Tridgell
8b7366d619
Plane: adjust throttle mix for auto landing
...
use mix-max during landing approach and initial descent, use min in
land final. As discussed with Leonard
2022-03-18 14:24:46 +11:00
Andrew Tridgell
6e3a2663bf
Plane: check that RTL_AUTOLAND is set if using DO_LAND_START
2022-03-18 14:23:23 +11:00
Andrew Tridgell
14571ee24b
Plane: added airspeed based pitch limit check
...
prevent using too much pitch when at low airspeed, which can lead to
severe instability in SLT quadplanes
2022-03-16 08:12:20 +11:00
Andrew Tridgell
d7052b4d5a
Plane: added an arming check for Q_ASSIST_SPEED
...
Q_ASSIST should really be enabled for all non-tailsitter
quadplanes. This arming check will help users remember to configure it
2022-03-16 07:09:30 +11:00
Andrew Tridgell
0bab0dc26c
Plane: use set_lean_angle_max_cd()
...
allows for a wider range of Q_TRANS_DECEL while landing on the desired
landing point
2022-03-16 07:09:30 +11:00
Andrew Tridgell
6839533e5d
Plane: improvements to POSITION1 controller
...
this improves 4 things in the POSITION1 controller based on logs from
4.2.0beta2. The changes are designed to increase the tolerance to
an incorrect value for Q_TRANS_DECEL, reducing landing overshoot
1) we fix the initialisation of the acceleration. The
init_xy_controller() function assumes zero accel, so we need to
call set_accel_desired_xy_cmss() just after that init to get the
correct accel. Thanks to Leonard for this fix
2) if we decel more than expected due to too low Q_TRANS_DECEL we
need to reduce the target speed, rather than putting the nose down
3) lower the default Q_P_JERK_XY to a value more appropriate for most
quadplanes (Leonard suggested a value of 2)
4) fixed the pitch envelope from Q_BACKTRANS_MS to start after the
airbrake phase is complete
2022-03-14 13:52:06 +11:00
Andrew Tridgell
965a571063
Plane: fixed pitch envelope after AIRBRAKE
...
we need to setup last_fw_mode_ms and last_fw_nav_pitch_cd when we
enter POSITION1 mode so that the expanding envelope pitch limit from
Q_BACKTRANS_MS is applied correctly
2022-03-14 11:06:29 +11:00
Andrew Tridgell
139411f0c5
Plane: prepare for 4.2.0beta2
2022-03-10 13:43:16 +11:00
Andrew Tridgell
42c2ec053a
Plane: added release notes for 4.2.0beta2
2022-03-10 13:43:08 +11:00
Andrew Tridgell
0aeb7e1500
Plane: protect against short stop_distance
2022-03-10 11:11:10 +11:00
Iampete1
8fd386f50b
Plane: quadplane: double log QPOS state change
2022-03-10 10:46:17 +11:00
Peter Barker
9981a08791
Plane: use has_valid_input in place of checking throttle counter
2022-03-10 10:45:39 +11:00
Henry Wurzburg
c8bc0b7e0d
ArduPlane: clarify and simplify RC failsafe messages
2022-03-10 10:44:56 +11:00
Peter Barker
f10f3da159
ArduPlane: add RebootRequred to stream rate parameters
2022-03-10 10:44:53 +11:00
Andrew Tridgell
e0e60c8654
Plane: disallow mavlink disarm while flying
...
this relies on is_flying(), and we will need to watch for reports of
the heuristics failing
2022-03-10 08:24:39 +11:00
Iampete1
a71b406287
ArduPlane: tailsitter: keep attitude controll throttle level upto date for smoother controller handover
2022-03-10 08:24:35 +11:00
Iampete1
d5af006e5c
Plane: never stick mix without valid RC input
2022-03-10 08:24:27 +11:00
Iampete1
7265ed552b
Plane: don't prevent stick mixing in none RC failsafe
2022-03-10 08:24:21 +11:00
Andrew Tridgell
1d2a64951c
Plane: use pos control for most of LAND_FINAL
...
this gives more accurate landing with some velocity drift
2022-03-10 07:36:30 +11:00
Andrew Tridgell
c4ce86a839
Plane: review fixes
...
thanks Pete!
2022-03-10 07:36:21 +11:00
Andrew Tridgell
c41a3af59d
Plane: wait till motors are fully up before takeoff in guided mode
...
this allows for guided mode takeoff in tilt-rotors. Otherwise motors
till be pointing forward and takeoff will go very badly
2022-03-10 07:36:08 +11:00
Andrew Tridgell
32404f5aa5
Plane: cope with high angle error in airbrake state
...
if we are flying too far off the target vector then exit airbrake
state. This prevents flying for a long distance away from the landing
point in airbrake mode
2022-03-10 07:36:05 +11:00
Andrew Tridgell
948ae05922
Plane: setup target accel in POSITION1 state
2022-03-10 07:36:01 +11:00
Andrew Tridgell
395cf1b6dd
Plane: allow for a trans decel margin
...
so if we are behind the velocity curve we are less likely to overshoot
landing
2022-03-10 07:35:58 +11:00
Andrew Tridgell
d0ce3c8774
Plane: fix NAV_CONTROLLER_OUTPUT in Q modes
...
Q modes don't always use wp_nav, but do use pos_control
AUTO and QRTL setup the plane navigation as well, so can use the L1
data
2022-03-10 07:35:32 +11:00
Andrew Tridgell
25f57af2e3
Plane: added APIs for lua ship landing
2022-03-10 07:35:29 +11:00
Andrew Tridgell
abae8518f0
Plane: link in AP_Follow
...
ready for ship landing
2022-03-10 07:35:25 +11:00
Andrew Tridgell
46ede1b73f
Plane: removed terrain home correction
2022-03-10 07:35:03 +11:00
Andrew Tridgell
38662b98d8
Plane: added Q_LAND_ALTCHG parameter
...
this is the threshold height change over 4 seconds for a landing to be
detected. It can be raised if landing detection is very slow
2022-03-09 07:50:54 +11:00
Andrew Tridgell
bb81a3bd3b
Plane: prepare for 4.2.0beta1
2022-03-02 07:42:57 +11:00
Andrew Tridgell
88de8cdc21
Plane: added release notes for 4.2.0beta1
2022-03-02 07:42:48 +11:00
Peter Barker
13fa1e30ad
ArduPlane: rename and make enum RC_Channel::ControlType
...
Type:: is too generic; get_type should probably be get_control_type
2022-02-27 09:55:01 +11:00