Commit Graph

84 Commits

Author SHA1 Message Date
priseborough d5442fe64e AP_NavEKF : Modified compass fail logic
If the vehicle can fly without a compass (a fly forward vehicle)
then if the compass times out (large errors for more than 10 seconds,
then it will be declared permanently failed and will not be
used until the filter is reset
2014-07-31 21:12:11 +10:00
Emile Castelnuovo 946a461873 VRBRAIN: added VRBRAIN to #if 2014-06-19 11:27:44 +02:00
Andrew Tridgell 5edf4ba596 AP_NavEKF: fixed up handling of bitfields in faultStatus
Pair-Programmed-With: Paul Riseborough <p_riseborough@live.com.au>
2014-05-15 21:42:39 +10:00
priseborough ce8e1daa16 AP_NavEKF: Improved divergence detection and reset
Divergence is now detected by looking for very large changes in the gyro
bias. This will cause the filter to be reset and declared unhealthy for
10 seconds.

Don't reset filterDiverged status immediately during reset

Set filterDiverged true if covariance blows up

Add fault status reporting
2014-05-15 21:14:21 +10:00
priseborough 925c5751bd AP_NavEKF: Add ability to inhibit in-flight mag cal and clean up moding
This will enable in-flight magnetometer calibration to be inhibited unconditionally,
This is required for long balloon carriage flights where ground speed can be high
enough to put it into in-air state, but with very poor observability of magnetic field
states causing bad state estimates and heading offsets to develop over time.

The covariance matrix no longer has rows and columns artificially zeroed when in static
mode. Instead booleans indicating whether wind or magentic field state estimation is
active are used to:

a) Set the process noise on these states to zero to stop their variances from increasing
unchecked when not being updated, and
b) Turn off updates for these states when measurement fusion is being performed.

This reduces the likelihood of a badly conditioned covariance matrix forming
during static mode operation.

A filter divergence check has also been added that will declare the filter unhealthy if
position, velocity and magnetic field observations are all failing their innovation
consistency checks. This unhealthy status will persist for 10 seconds after the
condition clears.

AP_NavEKF: Remove unnecessary zeroing of wind covariances
2014-05-11 18:00:38 +10:00
priseborough ecc8e45eda AP_NavEKF: Fix bug in position reset logic 2014-04-23 18:16:02 +10:00
Andrew Tridgell 25667a11a0 AP_NavEKF: use AHRS vehicle class for sideslip calculation
Pair-Programmed-With: Paul Riseborough <p_riseborough@live.com.au>
2014-04-21 18:13:12 +10:00
Andrew Tridgell 5acd17b843 AP_NavEKF: cleanup some build warnings
Pair-Programmed-With: Paul Riseborough <p_riseborough@live.com.au>
2014-04-21 18:13:12 +10:00
priseborough bd28cdbdcf AP_NavEKF: Improved magnetometer consistency checks
A magnetometer axis that fails the innovation consistency check will cause
all axes not to be used. If this condition continues for 10 seconds, a
magnetometer timeout condition will be declared. When the timeout has
occurred, if it is not a fly forward vehicle, then individual channels
will be used again, but with a reduced weighting.
2014-04-21 16:31:31 +10:00
priseborough 188bea6bab AP_NavEKF : Enable calc of wind velocity when not using airspeed sensing
This patch also cleans up the logic associated with use of the synthetic
sideslip measurement so that it can never be used for a non fly-forward
vehicle type

This patch adds functionality that initialises the wind-speed vector to the
reciprocal of the ground speed vector, and scaled to 6 m/s. On average this gives
a better initial wind velocity estimate on launch by assuming:

a) launch will be into wind
b) wind speed is equal to global average

It also helps prevent a headwind causing initial underestimation of airspeed
causing high autopilot gains and limit cycles on climb-out, until first
turn when the EKF is able to estimate the wind.
2014-04-13 19:37:19 +10:00
Emile Castelnuovo 25f1c5774f AP_NavEKF: added #defines for VRBRAIN board 2014-04-08 16:19:19 +10:00
Andrew Tridgell 07d621c4be AP_NavEKF: used state structure in more places
makes the code a bit easier to read

Pair-Programmed-With: Paul Riseborough <p_riseborough@live.com.au>
2014-04-04 21:30:16 +11:00
Andrew Tridgell cd3038fabd AP_NavEKF: fixed return of offset in getVariances() 2014-04-03 07:49:06 +11:00
priseborough 04036d7777 AP_NavEKF : Updated GPS glitch protection logic
This adds new functionality to the detection and compensation of GPS
glitches:

1) A maximum allowable innovation is calculated using the GPS noise
parameter multiplied by the gate, with an additional component allowing
for growth in position uncertainty due to acceleration error since
the last valid measurement
2) Includes per vehicle type values for the acceleration error limit
3) If the innovation length exceeds the maximum allowable, no fusion occurs
4) If no fusion has occurred for long enough such that the position uncertainty
exceeds the maximum set by a per vehicle parameter or a maximum time, an offset
is applied to the GPS data to so that it matches the value predicted by the filter
5) The offset is never allowed to be bigger than 100m
6) The offset is decayed to zero at a rate of 1.0 m/s to allow GPS jumps to
be accommodated gradually
7) The default velocity innovation gate has been tightened up for copter and rover
8) The variance data logging output has been updated to make it more useful
2014-04-01 21:22:14 +11:00
priseborough 17cdac7bc8 AP_NavEKF : Clean up angle and mag field initialisation
This path reduces duplicated code, eliminates unused variables and
causes the earth magnetic field states to be reset when exiting static mode
which will occur every time copter is armed. This enables copters to be
powered on and initialised inside vehicles or houses, without bad earth
field values affecting flight.
2014-03-24 19:54:48 +11:00
Paul Riseborough f7007569d1 AP_NavEKF : Fix bug that limits copter sensor delay compensation to 125
msec
2014-03-21 21:52:20 +11:00
Paul Riseborough 35811758d7 AP_NavEKF : Update comments and remove un-used function declarations 2014-03-14 06:07:57 +11:00
Paul Riseborough 7b3130cfcc AP_NaVEKF : Enable operation without airspeed and compass 2014-03-10 21:53:09 +11:00
Paul Riseborough 3a5acb9cea AP_NavEKF : improved on-ground, in-air check and GPS yaw alignment 2014-03-10 14:07:34 +11:00
Paul Riseborough b47a11edf6 AP_NavEKF : improved static and on-ground mode selection logic 2014-03-10 04:39:59 +11:00
Paul Riseborough 2019708056 AP_NavEKF : Make all compass use autodetect 2014-03-09 19:59:19 +11:00
Paul Riseborough e485b246e7 AP_NavEKF : update comments 2014-03-09 19:59:18 +11:00
Paul Riseborough c8bd415b00 AP_NavEKF : Add sideslip constraint to allow plane flight without magnetometer 2014-03-09 19:59:17 +11:00
Paul Riseborough 52fabc822f AP_NavEKF : Add low speed magnetometer calibration option 2014-03-09 19:59:16 +11:00
Andrew Tridgell 449d09051e AP_NavEKF: cope with compass going offline while in flight 2014-03-02 14:32:10 +11:00
Paul Riseborough bd152d332c AP_NavEKF : Add accel aliasing protection 2014-03-02 08:10:04 +11:00
Paul Riseborough 5db9a87d31 AP_NavEKF : fixed bug in velocity rate of change filter
This bug meant the velocity rate of change used to scale the GPS measurement variances was noisy and too small
2014-02-23 19:50:37 +11:00
Paul Riseborough 89e0b48320 AP_NavEKF : Bug fix for height drift due to timer wrap-around 2014-02-23 19:50:35 +11:00
Andrew Tridgell 4e56196655 AP_NavEKF: allow states to be accessed using names as well as a Vector22 2014-02-21 20:24:47 +11:00
Andrew Tridgell c9d0c1face AP_NavEKF: use ahrs->get_armed() for static mode demanded 2014-02-19 10:52:57 +11:00
Andrew Tridgell 536160a3fb AP_NavEKF: use AHRS get_correct_centrifugal() 2014-02-19 10:28:45 +11:00
Andrew Tridgell 869e41fd03 AP_NavEKF: fixed detection of airspeed sensor
the get_airspeed() AHRS call can change as the user enables/disables
the airspeed sensor, plus it only gets enabled after the NavEKF
constructor runs.
2014-02-19 09:22:45 +11:00
Paul Riseborough 1ade39977a AP_NavEKF : covariance prediction cleanup 2014-02-19 09:22:45 +11:00
Paul Riseborough 8daca145d0 AP_NavEKF : useAirspeed set automatically 2014-02-19 09:22:45 +11:00
Paul Riseborough 6fbada26d3 AP_NavEKF : Improvements to staticMode robustness 2014-02-19 09:22:45 +11:00
Paul Riseborough b22dc706b2 AP_NavEKF : staticMode bugfix and robustness improvements 2014-02-16 21:04:55 +11:00
Paul Riseborough b56c8211c9 AP_NavEKF: Reduced number of Mavlink tuneable parameters 2014-02-15 05:48:23 +11:00
Paul Riseborough c20fac1269 AP_NavEKF: Updated comments for private functions 2014-02-15 05:48:23 +11:00
Paul Riseborough deb64c4cbd AP_NavEKF: Pos Vel reset after long GPS timeout 2014-02-15 05:48:23 +11:00
Paul Riseborough 80f6dba694 AP_NavEKF: Improved control of fusion update intervals 2014-02-15 05:48:23 +11:00
Paul Riseborough 13b9daeff5 AP_NavEKF: Added constraints to Mavlink tuneable parameters 2014-02-15 05:48:23 +11:00
Paul Riseborough b123e1bb16 AP_NavEKF: Improved in-air reset behaviour 2014-02-15 05:48:22 +11:00
Paul Riseborough 1651980b9f AP_NavEKF: Improved behaviour following loss and regaining of GPS 2014-02-15 05:48:22 +11:00
Paul Riseborough 14eb63e7c9 AP_NavEKF: Made most tuning parameters Mavlink adustable 2014-02-15 05:48:22 +11:00
Andrew Tridgell f800f5592d AP_NavEKF: fixup parameter handling 2014-02-15 05:48:22 +11:00
Paul Riseborough f0f76920fa AP_NavEKF : Mavlink tunable parameter - first attempt 2014-02-15 05:48:22 +11:00
Paul Riseborough 128f71157d AP_NavEKF: Fixed bug in pre GPS fix updates 2014-02-15 05:48:22 +11:00
Paul Riseborough 5219869389 AP_NavEKF : Added Z accel bias state and bootstrap initialisation method 2014-02-15 05:48:21 +11:00
Randy Mackay 7c73020015 AP_NavEKF: make params public so they can be tuned 2014-02-15 05:48:20 +11:00
Paul Riseborough 5c3dea28dc AP_NavEKF : Enable staticMode to be set externally 2014-02-15 05:48:20 +11:00