Mykhailo Kuznietsov
3a7e939a6c
AP_GPS: Fix some typos
...
Fixed some typos found in the code.
2023-10-12 18:30:42 +11:00
Peter Barker
53115c73f9
AP_GPS: have AP_GPS_UBLOX use boolean uart read
2023-10-06 16:34:50 +11:00
Andrew Tridgell
89bd6ab218
AP_GPS: implement the GPS_DRV_OPTION for ellisoid height in mode drivers
...
this allows a lot more drivers to use the GPS_DRV_OPTION but to use
ellisoid height. Particularly useful for DroneCAN GPS modules
using ellisoid height instead of AMSL is useful in some specialised
application
2023-09-21 19:36:26 +10:00
Andrew Tridgell
0d4018107b
AP_GPS: fixed ublox M10S auto-config
...
this copes with the M10S rejecting multiple-key VALGET calls. We fall
back to fetching one at a time
2023-06-13 11:00:47 +10:00
Peter Barker
e415b5fda0
AP_GPS: add clarifying comment on _configure_config_set method
...
it's a bit confusingly named, because it doesn't actually "set" anything - it gets messages from the GPS which are then parsed and responded to based on the received values.
2023-05-29 09:56:20 +10:00
Andrew Tridgell
fd0bf49ca5
AP_GPS: don't try and configure M10 options on non-M10 GPS
...
this fixes a pre-arm failure "GPS 1 failing configuration checks" on
non-M10 GPS modules, including AP_Periph
it also adds the ublox unconfigured msgs to the DroneCAN GNSS.Status
errors field for easier diagnosis of this type of issue in the future
2023-02-18 15:33:13 +11:00
Andrew Tridgell
2fd575aca2
AP_GPS: allow for DroneCAN GPS other than u-blox rover with yaw
...
single module, dual antenna GPS can give yaw information
2022-12-20 10:23:58 +11:00
Andrew Tridgell
9cebe3b880
AP_GPS: added a common velocity_to_speed_course()
...
this saves flash using common code
2022-12-20 10:23:58 +11:00
Andrew Tridgell
b12cd48843
AP_GPS: improve support for uBlox-M10
...
this sets up the M10 to use the BaiDou B1C signal instead of B1, and
disables glonass. This is needed to get a consistent 5Hz lock
2022-11-22 19:51:01 +11:00
Joshua Henderson
378dff5568
AP_GPS: added get_undulation support
2022-08-09 14:37:08 +10:00
Peter Barker
b88f414320
AP_GPS: allow UBLOX driver to be compiled out
2022-07-13 17:56:38 +10:00
Andrew Tridgell
06a9a1521c
AP_GPS: added GPS_DRV_OPTIONS bit for ellipsoid height
2022-06-15 17:30:28 +10:00
Iampete1
2589fa1b3b
AP_GPS: UBlox: add TIM-TM2 logging
2022-04-06 17:22:30 +10:00
Peter Barker
cafad05b38
AP_GPS: rearrange send-text for consistency
2022-03-27 06:21:20 -07:00
bugobliterator
46294c0fba
AP_GPS: sync pps rate with message rate
2022-01-20 17:26:35 +11:00
bugobliterator
9834304525
AP_GPS: make more precise calculation of gps message
...
use PPS signal if available as well
2022-01-20 17:26:35 +11:00
Peter Barker
8d17b8dbe7
AP_GPS: use const structure for saving GPS config
2022-01-12 18:29:01 +11:00
Peter Barker
1943de9016
AP_GPS: tidy configuration of UBLOX rates
2022-01-12 18:29:01 +11:00
Andrew Tridgell
9d21c0b6c1
AP_GPS: added GPS data logging system
...
for debugging GPS protocols
2022-01-11 10:34:11 +11:00
Peter Barker
065cb2decb
AP_GPS_UBLOX: tidy reading of uart data
...
Neither of the return types used for data and numc were actually correct for the values being returned from the uartdriver functions.
2021-11-09 10:31:25 +11:00
Josh Henderson
06251335da
AP_GPS: use vector.xy().length() instead of norm(x,y)
2021-09-14 10:43:46 +10:00
bugobliterator
85d8becb8c
AP_GPS: add support for auto config Moving Baseline for AP_Periph GPS
2021-08-19 14:20:58 +10:00
bugobliterator
9fc57e40b4
AP_GPS: add support for dual GPS heading using Periph GPSes
2021-08-19 14:20:58 +10:00
Siddharth Purohit
c18652f35a
AP_GPS: add option to enable configuring PPS pin in UBLOX driver
2021-07-02 08:50:16 +10:00
Peter Barker
a61b6ebda8
AP_GPS: move from HAL_NO_LOGGING to HAL_LOGGING_ENABLED
2021-05-19 17:38:47 +10:00
Michael du Breuil
1288f4c81b
AP_GPS: Support GPS_SBAS_MODE on SBF GPS units
...
Also swaps to using an AP_Enum for the SBAS type, and fixes up the fact
that the prearm/failure reasons should be using the config step, rather
then the init blob index
2021-05-18 09:52:07 +10:00
Andrew Tridgell
7cc11e6856
AP_GPS: fixed handling of loss of GPS yaw
...
when the GPS yaw data doesn't pass the internal tests of validity for
400ms we need to stop telling the EKF that we have valid yaw
2021-05-04 10:37:15 +10:00
giacomo892
a245100ae6
AP_GPS_UBLOX: Fix GALILEO auto configuration
2021-04-29 13:01:09 +10:00
Patrick José Pereira
6bdc1704f4
AP_GPS: Remove pointer check before delete
...
Signed-off-by: Patrick José Pereira <patrickelectric@gmail.com>
2021-02-04 09:01:19 +11:00
Peter Barker
428c9ef0e1
AP_GPS: correct logging in dual-ublox setups
2020-11-10 17:39:51 +11:00
Michael du Breuil
4161e2eb28
AP_GPS: Factor out moving base offset helper
2020-11-03 11:12:20 +11:00
Andrew Tridgell
8e08d93026
AP_GPS: fixed pre-arm check on ublox M9 GPS
...
this prevents a failure from config of SOL and TMODE messages
2020-10-06 10:22:52 +11:00
Andrew Tridgell
4f591a338f
AP_GPS: use GCS_SEND_TEXT()
2020-04-29 07:36:55 +10:00
Andrew Tridgell
6347d0adb0
AP_GPS: leave uart2 config enabled when using uart2 MB setup
2020-04-21 15:30:54 +10:00
Andrew Tridgell
3397ed766d
AP_GPS: enable ublox moving baseline compilation option
...
disable for HAL_MINIMIZE_FEATURES and if max receivers 1. This fixes
the f103-GPS AP_Periph build
2020-04-21 15:30:54 +10:00
Andrew Tridgell
ae2132d861
AP_GPS: added check for Z error in moving baseline ublox
...
this ensures we don't get bad yaw from having the right distance but
incorrect Z offset for the currently expected roll/pitch
2020-04-21 15:30:54 +10:00
Andrew Tridgell
7027eecd34
AP_GPS: added GPS_DRV_OPTIONS
...
this allows for configuration of moving baseline with either uart1 or
uart2 for the RTCM data. Using uart2 requires an extra cable between
the two modules, but requires less uart bandwidth which is good when
DMA channels are low. Using uart2 also avoids the rtcmv3 parser, which
saves memory
2020-04-21 15:30:54 +10:00
Andrew Tridgell
9a6de209ab
AP_GPS: ensure that PVT and RELPOSNED msgs time align
...
this ensures we wait until we have a matching PVT and RELPOSNED
message before we report new data. If we stop receiving RELPOSNED
messages then disable yaw support
2020-04-21 15:30:54 +10:00
Andrew Tridgell
3fbeae613b
AP_GPS: fixed moving baseline yaw calculation
...
this reverts #13955 and instead applies the correct fix, which is to
subtract the angle instead of adding.
2020-04-21 15:30:54 +10:00
Andrew Tridgell
4456732911
AP_GPS: fixed rotation of moving baseline GPS
...
we were off by 180 degrees. Thanks to Jaime for noticing this!
2020-04-01 17:08:19 +11:00
Andrew Tridgell
e59f32074d
AP_GPS: fixed yaw error when one GPS has zero position
...
the M_PI correction was only valid for one zero side. Much simpler to
always calculate difference
2020-01-24 11:46:40 +11:00
Andrew Tridgell
db777c56b9
AP_GPS: provide yaw feedback in GPS_RAW_INT and GPS2_RAW
...
allow GPS to display status of GPS yaw for moving baseline and NMEA
2020-01-07 12:37:35 +11:00
Andrew Tridgell
e40c570615
AP_GPS: faster config of moving baseline
...
thanks to MdB for suggestion
2020-01-07 12:37:35 +11:00
Andrew Tridgell
e660532f67
AP_GPS: fixes from PR review
2020-01-07 12:37:35 +11:00
Andrew Tridgell
41289fe945
AP_GPS: adjust lag for MB RTK ublox
...
rover will lag by about 40ms
2020-01-07 12:37:35 +11:00
Andrew Tridgell
93aaf98672
AP_GPS: added automatic u-blox moving baseline configuration
...
this uses GPS_TYPE and GPS_TYPE2 to setup two u-blox F9 receivers in a
RTK moving baseline configuration
2020-01-07 12:37:35 +11:00
Andrew Tridgell
379e3d60a1
AP_GPS: fixed sizes of config items
2019-11-16 15:28:52 +11:00
Michael du Breuil
63a6a1084c
AP_GPS: UBlox: Fix the assumption that all keys are 1 byte keys
2019-11-16 15:28:52 +11:00
Michael du Breuil
150a4edcf2
AP_GPS: UBlox fix not listing the time mode as a configuration reason
2019-11-16 15:28:52 +11:00
Andrew Tridgell
7bec9d87b4
AP_GPS: fixed TMODE config issue on non-F9 GPS
...
thanks to Michel Pastor for reporting this
2019-11-16 15:28:52 +11:00