ardupilot/libraries/AP_InertialSensor/examples/MPU6000/MPU6000.pde

// -*- tab-width: 4; Mode: C++; c-basic-offset: 4; indent-tabs-mode: t -*-

//
// Simple test for the AP_InertialSensor MPU6000 driver.
//

#include <FastSerial.h>
#include <SPI.h>
#include <Arduino_Mega_ISR_Registry.h>
#include <AP_PeriodicProcess.h>
#include <AP_InertialSensor.h>
#include <AP_Math.h>
#include <AP_Common.h>

FastSerialPort(Serial, 0);

Arduino_Mega_ISR_Registry isr_registry;
AP_TimerProcess scheduler;
AP_InertialSensor_MPU6000 ins( 53 ); /* chip select is pin 53 */

void setup(void)
{
    Serial.begin(115200);
    Serial.println("Doing INS startup...");

    SPI.begin();
    SPI.setClockDivider(SPI_CLOCK_DIV16); // 1MHZ SPI rate

    isr_registry.init();
    scheduler.init(&isr_registry);

    // we need to stop the barometer from holding the SPI bus
    pinMode(40, OUTPUT);
    digitalWrite(40, HIGH);

    ins.init(&scheduler);
}

void loop(void)
{
    float accel[3];
    float gyro[3];
    float temperature;

    delay(20);
    ins.update();
    ins.get_gyros(gyro);
    ins.get_accels(accel);
    temperature = ins.temperature();

    Serial.printf("AX: %f  AY: %f  AZ: %f  GX: %f  GY: %f  GZ: %f T=%f\n",
                  accel[0], accel[1], accel[2], gyro[0], gyro[1], gyro[2], temperature);
}