ardupilot/libraries/AP_HAL_ChibiOS/hwdef/YJUAV_A6SE/defaults.parm

# setup the heater temperature to 45 degree
BRD_HEAT_TARG 45

# turn on the CAN power monitoring(default)
CAN_P1_DRIVER 1
BATT_MONITOR 4

# setup the parameter for the ADC power module
BATT_VOLT_PIN 2
BATT_CURR_PIN 4
BATT_VOLT_MULT 18.000
BATT_AMP_PERVLT 24.000

# setup the parameter for the ADC rssi 
RSSI_ANA_PIN 11
HAL_ChibiOS: added YJUAV_A6SE support 2023-08-08 12:58:10 -03:00			`# setup the heater temperature to 45 degree`
			`BRD_HEAT_TARG 45`

			`# turn on the CAN power monitoring(default)`
			`CAN_P1_DRIVER 1`
			`BATT_MONITOR 4`

			`# setup the parameter for the ADC power module`
hwdef: Modify YJUAV_A6SE board TIME12 to TIM8 2023-09-07 06:01:42 -03:00			`BATT_VOLT_PIN 2`
HAL_ChibiOS: added YJUAV_A6SE support 2023-08-08 12:58:10 -03:00			`BATT_CURR_PIN 4`
			`BATT_VOLT_MULT 18.000`
			`BATT_AMP_PERVLT 24.000`

			`# setup the parameter for the ADC rssi`
			`RSSI_ANA_PIN 11`