#include "Copter.h"

#if MODE_BRAKE_ENABLED == ENABLED

/*
 * Init and run calls for brake flight mode
 */

// brake_init - initialise brake controller
bool ModeBrake::init(bool ignore_checks)
{
    // initialise pos controller speed and acceleration
    pos_control->set_max_speed_accel_xy(inertial_nav.get_velocity_neu_cms().length(), BRAKE_MODE_DECEL_RATE);
    pos_control->set_correction_speed_accel_xy(inertial_nav.get_velocity_neu_cms().length(), BRAKE_MODE_DECEL_RATE);

    // initialise position controller
    pos_control->init_xy_controller();

    // set vertical speed and acceleration limits
    pos_control->set_max_speed_accel_z(BRAKE_MODE_SPEED_Z, BRAKE_MODE_SPEED_Z, BRAKE_MODE_DECEL_RATE);
    pos_control->set_correction_speed_accel_z(BRAKE_MODE_SPEED_Z, BRAKE_MODE_SPEED_Z, BRAKE_MODE_DECEL_RATE);

    // initialise the vertical position controller
    if (!pos_control->is_active_z()) {
        pos_control->init_z_controller();
    }

    _timeout_ms = 0;

    return true;
}

// brake_run - runs the brake controller
// should be called at 100hz or more
void ModeBrake::run()
{
    // if not armed set throttle to zero and exit immediately
    if (is_disarmed_or_landed()) {
        make_safe_ground_handling();
        pos_control->relax_z_controller(0.0f);
        return;
    }

    // set motors to full range
    motors->set_desired_spool_state(AP_Motors::DesiredSpoolState::THROTTLE_UNLIMITED);

    // relax stop target if we might be landed
    if (copter.ap.land_complete_maybe) {
        pos_control->soften_for_landing_xy();
    }

    // use position controller to stop
    Vector2f vel;
    Vector2f accel;
    pos_control->input_vel_accel_xy(vel, accel);
    pos_control->update_xy_controller();

    // call attitude controller
    attitude_control->input_thrust_vector_rate_heading(pos_control->get_thrust_vector(), 0.0f);

    pos_control->set_pos_target_z_from_climb_rate_cm(0.0f);
    pos_control->update_z_controller();

    // MAV_CMD_SOLO_BTN_PAUSE_CLICK (Solo only) is used to set the timeout.
    if (_timeout_ms != 0 && millis()-_timeout_start >= _timeout_ms) {
        if (!copter.set_mode(Mode::Number::LOITER, ModeReason::BRAKE_TIMEOUT)) {
            copter.set_mode(Mode::Number::ALT_HOLD, ModeReason::BRAKE_TIMEOUT);
        }
    }
}

/**
 * Set a timeout for the brake mode
 * 
 * @param timeout_ms [in] timeout in milliseconds
 * 
 * @note MAV_CMD_SOLO_BTN_PAUSE_CLICK (Solo only) is used to set the timeout.
 * If the timeout is reached, the mode will switch to loiter or alt hold depending on the current mode.
 * If timeout_ms is 0, the timeout is disabled.
 * 
*/
void ModeBrake::timeout_to_loiter_ms(uint32_t timeout_ms)
{
    _timeout_start = millis();
    _timeout_ms = timeout_ms;
}

#endif