// -*- tab-width: 4; Mode: C++; c-basic-offset: 4; indent-tabs-mode: nil -*- // filter altitude from the barometer with a low pass filter static LowPassFilterInt32 altitude_filter; static void init_barometer(void) { gcs_send_text_P(SEVERITY_LOW, PSTR("Calibrating barometer")); barometer.calibrate(); // filter at 100ms sampling, with 0.7Hz cutoff frequency altitude_filter.set_cutoff_frequency(0.1, 0.7); gcs_send_text_P(SEVERITY_LOW, PSTR("barometer calibration complete")); } // read the barometer and return the updated altitude in centimeters // above the calibration altitude static int32_t read_barometer(void) { barometer.read(); return altitude_filter.apply(barometer.get_altitude() * 100.0); } // in M/S * 100 static void read_airspeed(void) { if (airspeed.enabled()) { airspeed.read(); calc_airspeed_errors(); } } static void zero_airspeed(void) { airspeed.calibrate(); gcs_send_text_P(SEVERITY_LOW,PSTR("zero airspeed calibrated")); } static void read_battery(void) { if(g.battery_monitoring == 0) { battery.voltage = 0; return; } if(g.battery_monitoring == 3 || g.battery_monitoring == 4) { // this copes with changing the pin at runtime batt_volt_pin->set_pin(g.battery_volt_pin); battery.voltage = BATTERY_VOLTAGE(batt_volt_pin); } if (g.battery_monitoring == 4) { static uint32_t last_time_ms; uint32_t tnow = hal.scheduler->millis(); float dt = tnow - last_time_ms; if (last_time_ms != 0 && dt < 2000) { // this copes with changing the pin at runtime batt_curr_pin->set_pin(g.battery_curr_pin); battery.current_amps = CURRENT_AMPS(batt_curr_pin); // .0002778 is 1/3600 (conversion to hours) battery.current_total_mah += battery.current_amps * dt * 0.0002778f; } last_time_ms = tnow; } if (battery.voltage != 0 && g.fs_batt_voltage > 0 && battery.voltage < g.fs_batt_voltage) { low_battery_event(); } if (g.battery_monitoring == 4 && g.fs_batt_mah > 0 && g.pack_capacity - battery.current_total_mah < g.fs_batt_mah) { low_battery_event(); } } // read the receiver RSSI as an 8 bit number for MAVLink // RC_CHANNELS_SCALED message void read_receiver_rssi(void) { rssi_analog_source->set_pin(g.rssi_pin); float ret = rssi_analog_source->voltage_average() * 50; receiver_rssi = constrain_int16(ret, 0, 255); } /* return current_loc.alt adjusted for ALT_OFFSET This is useful during long flights to account for barometer changes from the GCS, or to adjust the flying height of a long mission */ static int32_t adjusted_altitude_cm(void) { return current_loc.alt - (g.alt_offset*100); }