// -*- tab-width: 4; Mode: C++; c-basic-offset: 4; indent-tabs-mode: nil -*- static void failsafe_short_on_event(int16_t fstype) { // This is how to handle a short loss of control signal failsafe. failsafe = fstype; ch3_failsafe_timer = millis(); gcs_send_text_P(SEVERITY_LOW, PSTR("Failsafe - Short event on, ")); switch(control_mode) { case MANUAL: case STABILIZE: case FLY_BY_WIRE_A: case FLY_BY_WIRE_B: case TRAINING: set_mode(CIRCLE); break; case AUTO: case GUIDED: case LOITER: if(g.short_fs_action == 1) { set_mode(RTL); } break; case CIRCLE: case RTL: default: break; } gcs_send_text_fmt(PSTR("flight mode = %u"), (unsigned)control_mode); } static void failsafe_long_on_event(int16_t fstype) { // This is how to handle a long loss of control signal failsafe. gcs_send_text_P(SEVERITY_LOW, PSTR("Failsafe - Long event on, ")); // If the GCS is locked up we allow control to revert to RC hal.rcin->clear_overrides(); failsafe = fstype; switch(control_mode) { case MANUAL: case STABILIZE: case FLY_BY_WIRE_A: case FLY_BY_WIRE_B: case TRAINING: case CIRCLE: set_mode(RTL); break; case AUTO: case GUIDED: case LOITER: if(g.long_fs_action == 1) { set_mode(RTL); } break; case RTL: default: break; } gcs_send_text_fmt(PSTR("flight mode = %u"), (unsigned)control_mode); } static void failsafe_short_off_event() { // We're back in radio contact gcs_send_text_P(SEVERITY_LOW, PSTR("Failsafe - Short event off")); failsafe = FAILSAFE_NONE; // re-read the switch so we can return to our preferred mode // -------------------------------------------------------- if (control_mode == CIRCLE || (g.short_fs_action == 1 && control_mode == RTL)) { reset_control_switch(); } } void low_battery_event(void) { if (battery.low_batttery) { return; } gcs_send_text_fmt(PSTR("Low Battery %.2fV Used %.0f mAh"), battery.voltage, battery.current_total_mah); set_mode(RTL); g.throttle_cruise = THROTTLE_CRUISE; battery.low_batttery = true; } //////////////////////////////////////////////////////////////////////////////// // repeating event control /* update state for MAV_CMD_DO_REPEAT_SERVO and MAV_CMD_DO_REPEAT_RELAY */ static void update_events(void) { if (event_state.repeat == 0 || (millis() - event_state.start_time_ms) < event_state.delay_ms) { return; } // event_repeat = -1 means repeat forever if (event_state.repeat != 0) { event_state.start_time_ms = millis(); switch (event_state.type) { case EVENT_TYPE_SERVO: hal.rcout->enable_ch(event_state.rc_channel); if (event_state.repeat & 1) { servo_write(event_state.rc_channel, event_state.undo_value); } else { servo_write(event_state.rc_channel, event_state.servo_value); } break; case EVENT_TYPE_RELAY: relay.toggle(); break; } if (event_state.repeat > 0) { event_state.repeat--; } } }