/// -*- tab-width: 4; Mode: C++; c-basic-offset: 4; indent-tabs-mode: nil -*- #include "Copter.h" /* * Init and run calls for brake flight mode */ // brake_init - initialise brake controller bool Copter::brake_init(bool ignore_checks) { if (position_ok() || ignore_checks) { // set desired acceleration to zero wp_nav.clear_pilot_desired_acceleration(); // set target to current position wp_nav.init_brake_target(BRAKE_MODE_DECEL_RATE); // initialize vertical speed and acceleration pos_control.set_speed_z(BRAKE_MODE_SPEED_Z, BRAKE_MODE_SPEED_Z); pos_control.set_accel_z(BRAKE_MODE_DECEL_RATE); // initialise position and desired velocity pos_control.set_alt_target(inertial_nav.get_altitude()); pos_control.set_desired_velocity_z(inertial_nav.get_velocity_z()); brake_timeout_ms = 0; return true; }else{ return false; } } // brake_run - runs the brake controller // should be called at 100hz or more void Copter::brake_run() { // if not auto armed set throttle to zero and exit immediately if (!motors.armed() || !ap.auto_armed || !motors.get_interlock()) { wp_nav.init_brake_target(BRAKE_MODE_DECEL_RATE); #if FRAME_CONFIG == HELI_FRAME // Helicopters always stabilize roll/pitch/yaw // call attitude controller attitude_control.input_euler_angle_roll_pitch_euler_rate_yaw(0, 0, 0, get_smoothing_gain()); attitude_control.set_throttle_out(0,false,g.throttle_filt); #else motors.set_desired_spool_state(AP_Motors::DESIRED_SPIN_WHEN_ARMED); // multicopters do not stabilize roll/pitch/yaw when disarmed attitude_control.set_throttle_out_unstabilized(0,true,g.throttle_filt); #endif pos_control.relax_alt_hold_controllers(get_throttle_pre_takeoff(0)-motors.get_throttle_hover()); return; } // relax stop target if we might be landed if (ap.land_complete_maybe) { wp_nav.loiter_soften_for_landing(); } // if landed immediately disarm if (ap.land_complete) { init_disarm_motors(); } // set motors to full range motors.set_desired_spool_state(AP_Motors::DESIRED_THROTTLE_UNLIMITED); // run brake controller wp_nav.update_brake(ekfGndSpdLimit, ekfNavVelGainScaler); // call attitude controller attitude_control.input_euler_angle_roll_pitch_euler_rate_yaw(wp_nav.get_roll(), wp_nav.get_pitch(), 0.0f, get_smoothing_gain()); // body-frame rate controller is run directly from 100hz loop // update altitude target and call position controller pos_control.set_alt_target_from_climb_rate_ff(0.0f, G_Dt, false); pos_control.update_z_controller(); if (brake_timeout_ms != 0 && millis()-brake_timeout_start >= brake_timeout_ms) { if (!set_mode(LOITER, MODE_REASON_BRAKE_TIMEOUT)) { set_mode(ALT_HOLD, MODE_REASON_BRAKE_TIMEOUT); } } } void Copter::brake_timeout_to_loiter_ms(uint32_t timeout_ms) { brake_timeout_start = millis(); brake_timeout_ms = timeout_ms; }