# KakuteH7 v2 with flash chip for logging

include ../KakuteH7-bdshot/hwdef.dat

undef sdcard
undef mpu6000
undef IMU
undef HAL_OS_FATFS_IO
undef HAL_BOARD_LOG_DIRECTORY
undef HAL_BOARD_TERRAIN_DIRECTORY
undef PA3 PA0 PA2 PC8 PC9 PD8 PD9 PD0 PD1 PC6 PC7 PE7 PE8

MCU_CLOCKRATE_MHZ 480

# Holybro documentation:
# UART6 - RX
# UART1 - DJI RX
# UART4 - GPS
# UART3 - VTX

# USART3 (VTX)
PD8 USART3_TX USART3 NODMA
PD9 USART3_RX USART3 NODMA

# UART4 (GPS)
PD0 UART4_RX UART4
PD1 UART4_TX UART4

# UART6 (RX)
PC7 USART6_RX USART6
PC6 USART6_TX USART6

# UART7 (ESC Telemetry)
PE7 UART7_RX UART7 NODMA
PE8 UART7_TX UART7 NODMA

PA0  TIM5_CH1 TIM5 PWM(5) GPIO(54) BIDIR
PA2  TIM5_CH3 TIM5 PWM(6) GPIO(55) BIDIR
PC8  TIM8_CH3 TIM8 PWM(7) GPIO(56) BIDIR
PC9  TIM8_CH4 TIM8 PWM(8) GPIO(57)

# VTX Power control - should be high at startup to ensure power
PB11 VTX_PWR OUTPUT HIGH GPIO(81)
define RELAY2_PIN_DEFAULT 81

define HAL_BATT_MONITOR_DEFAULT 4

# second battery sensor on second ESC connector
PA1 BATT2_VOLTAGE_SENS ADC1 SCALE(1)
PC4 BATT2_CURRENT_SENS ADC1 SCALE(1)

# second battery setup (note external current sensor required)
define HAL_BATT2_VOLT_PIN 17
define HAL_BATT2_CURR_PIN 4
define HAL_BATT2_VOLT_SCALE 11.0
define HAL_BATT2_CURR_SCALE 59.5
define HAL_BATT2_MONITOR_DEFAULT 4

SPIDEV dataflash SPI1 DEVID1 SDCARD_CS      MODE3 104*MHZ 104*MHZ
SPIDEV bmi270    SPI4 DEVID1 mpu6000_CS      MODE3  1*MHZ  10*MHZ # Clock is 100Mhz so highest clock <= 10Mhz is 100Mhz/16

IMU BMI270 SPI:bmi270 ROTATION_ROLL_180

DMA_PRIORITY TIM3* TIM2* TIM5* TIM8* SPI4* SPI1*
DMA_NOSHARE *UP SPI1*

# Motor order implies Betaflight/X for standard ESCs
define HAL_FRAME_TYPE_DEFAULT 12
define HAL_LOGGING_DATAFLASH_ENABLED 1
define HAL_LOGGING_DATAFLASH_DRIVER AP_Logger_W25N01GV

define DEFAULT_NTF_LED_TYPES 257